STEVAL-ISA025V1 STMicroelectronics, STEVAL-ISA025V1 Datasheet - Page 18

• Manufacturer Part Number: STEVAL-ISA025V1
• Description: EVAL BOARD 30A 400KHZ L6730
• Manufacturer: STMicroelectronics
• Type: DC/DC Switching Converters, Regulators & Controllersr

Specifications of STEVAL-ISA025V1

• Design Resources: STEVAL-ISA025V1 Gerber Files STEVAL-ISA025V1 Schematic STEVAL-ISA025V1 Bill of Materials
• Main Purpose: DC/DC, Step Down
• Outputs And Type: 1, Non-Isolated
• Voltage - Output: 3.3V
• Current - Output: 30A
• Voltage - Input: 4.5 ~ 14V
• Regulator Topology: Buck
• Frequency - Switching: 400kHz
• Board Type: Fully Populated
• Utilized Ic / Part: L6730
• Input Voltage: 4.5 V to 14 V
• Output Voltage: 3.3 V
• Product: Power Management Modules
• Silicon Manufacturer: ST Micro
• Silicon Core Number: L6730
• Kit Application Type: Power Management - Voltage Regulator
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: L6730
• Other names: 497-5868

Device description
18/52
The output of the error amplifier is clamped with this voltage (Vss) until it reaches the
programmed value. No switching activity is observable if V
MOSFETs are off. When Vss is between 0.5 V and 1.1 V the low-side MOSFET is turned on
because the output of the error amplifier is lower than the valley of the triangular wave and
so the duty-cycle is 0%. As V
limit) even the high-side MOSFET begins to switch and the output voltage starts to increase.
The L6730 - L6730B can only source current during the soft-start phase in order to manage
the pre-bias start-up applications. This means that when the startup occurs with output
voltage greater than 0V (pre-bias startup), even when Vss is between 0.5 V and 1.1 V the
low-side MOSFET is kept OFF (see
Figure 9.
Figure 10. Start-up with pre-bias
The L6730B can always sink current and so it can be used to supply the DDR memory
termination BUS. If overcurrent is detected during the soft-start phase, the device provides
constant current-protection. In case there is short soft-start time and/or small inductor value
and/or high output capacitors value and thus, in case of high ripple current during the soft-
start, the converter can start-up in anyway and limit the current
Start-up without pre-bias
SS
Doc ID 11938 Rev 3
reaches 1.1 V (i.e. the oscillator triangular wave inferior
Figure 9
and
Figure
10).
SS
is lower than 0.5 V and both
(Chapter 5.8: Monitoring and
LGate
V
V
LGate
V
I
SS
V
OUT
L
OUT
SS
I
L
L6730 - L6730B