101-0577 Rabbit Semiconductor, 101-0577 Datasheet - Page 15

• Manufacturer Part Number: 101-0577
• Description: KIT DEV FOR BL2500 COYOTE
• Manufacturer: Rabbit Semiconductor
• Series: Coyoter
• Type: Single Board Computers (SBC)r

Specifications of 101-0577

• Contents: SBC, Dev. Board, AC Adapter, Cable and Dynamic C® CD-ROM
• Product: Modules
• Data Bus Width: 10 bit
• Processor Type: Rabbit 3000
• Sram: 128 KB
• Flash: 256 KB
• Number Of I/os: 24
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 8 V to 40 V
• Power Consumption: 1 W
• Board Size: 100 mm x 100 mm x 29 mm
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: BL2510
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2.1 Preparing the BL2500 for Development
Position the BL2500 as shown below in Figure 3. Attach the four nylon 4-40 × ¼ machine
screws and nuts supplied with the Development Kit in the holes at the corners as shown.
The nylon screws serve as standoffs to facilitate handling the BL2500 during develop-
ment, and protect the bottom of the printed circuit board against scratches or short circuits
while you are working with the BL2500.
User’s Manual
Chapter 2 explains how to connect the programming cable and
power supply to the BL2500.
NOTE: You will have to remove the RabbitCore module to install one screw under the
module. When replacing the RabbitCore module, it is important that you line up the pins
on the module exactly with the corresponding pins on the BL2500. The header pins may
become bent or damaged if the pin alignment is offset, and the module will not work.
Permanent electrical damage may also result if a misaligned module is powered up.
Figure 3. Attach Nylon Screws to BL2500 Board
2. G
ETTING
S
TARTED
9