EDK2612 Renesas Electronics America, EDK2612 Datasheet

Page 1

... EDK2612 U M SER ANUAL F H8S/2612 FLASH M N CHIP ICROCONTROLLER ...

Page 2

Preface Cautions 1. This document may be, wholly or partially, subject to change without notice. 2. All rights reserved. No one is permitted to reproduce or duplicate, in any form, a part or this entire document without Hitachi Micro Systems ...

Page 3

T C ABLE OF ONTENTS ............................................................................................................................................. 3 ABLE OF ONTENTS ....................................................................................................................................... 4 TART UP NSTRUCTIONS 2.1. INSTALLING THE EVALUATION DEVELOPMENT KIT (EDK)........................................................................... 4 2.2. SERIAL CONNECTION ....................................................................................................................................... 4 2.3. POWER SUPPLY ................................................................................................................................................ ...

Page 4

TART UP NSTRUCTIONS 2. NSTALLING THE VALUATION Please refer to the quick start guide provided for initial installation of the EDK. A copy of the quick start guide and other information relating to this ...

Page 5

EDK B L OARD AYOUT The diagram shows a general layout of the EDK board. FLASH Programming Power NMI Switch BOOT LED Power LED User1 LED User2 LED RESET BOOT Switch Switch CJ5 9-W ay D-Type CJ4 3.1. EDK ...

Page 6

EDK O PERATION 4.1. USER INTERFACE The EDK provides three buttons for influencing the operation of the board. The purpose of each button is clearly marked next to it. Refer to the board layout for positions (Section 3) 1. ...

Page 7

C C RYSTAL HOICE The operating crystal frequency has been chosen to support the fastest operation with the fastest serial operating speeds. The value of the crystal is 18.432MHz. The following table shows the baud rates and Baud Rate ...

Page 8

M M EMORY AP Table 4-4 illustrates the EDK memory map for mode 7. Section End Section Start H’00000000 H’01FFFF H’FFE000 H’FFEFBF H’FFF800 H’FFFF3F H’FFFF60 H’FFFFBF H’FFFFC0 H’FFFFFF 4.5. LED S The EDK has four red LEDs. The function ...

Page 9

B O OARD PTIONS The EDK has a number of configuration settings set by jumpers CJ4 ( CJ5 ( and zero-ohm links. Common EDK functions can be set using the jumpers as described ...

Page 10

– CJ5 SER ODE ETTINGS CJ5 is used to set the operating mode of the microcontroller. These jumpers must be fitted at all times to ensure correct operation of the EDK. Jumper CJ 5-A User Mode ...

Page 11

ERIAL ORT ELECTION The programming serial port is connected to the RS232 connector by default. This allows direct programming of the EDK using the supplied software tools. A secondary serial port is available on the microcontroller ...

Page 12

B C OOT ONTROL The method for placing the microcontroller device in to Boot mode for reprogramming has been incorporated into a complex programmable logic device (CPLD). This is not necessary for most user designs but allows a measure ...

Page 13

... For information about the H8S series microcontrollers refer to the H8S Series Hardware Manual For information about the H8S assembly language, refer to the H8S Series Programming Manual Further information available for this product can be found on the HMSE web site at: http://www.hmse.com/products/edk/support/edk2612.htm General information on Hitachi Microcontrollers can be found at the following URLs. Global: http://www ...