FS-940 Digi International, FS-940 Datasheet - Page 16

• Manufacturer Part Number: FS-940
• Description: JTAG-BOOSTER FOR ADSP-21XXX 5V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-940

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: ADI ADSP-21xxx, 5V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

1.9.
16
80386 or greater required
The JTAG-BOOSTER does not work on a 8088/8086 or a 80286 platform.
Adapter not connected or target power fail
The JTAG-Booster wasn't found. Please check connection to parallel port
and connection to target. Check target power. Check your BIOS-Setup.
Can't open x:\yyy\zzz\JTAGxxx.OVL
The overlay file JTAGxxx.OVL must be in the same directory as
JTAGxxx.EXE.
Configuration file XYZ not found.
The file specified with the option /INI= wasn't found.
Device offset out of range
The value specified with the option /OFFSET= is greater than the size of
the detected flash device.
Disk full
Writing a output file was aborted as a result of missing disk space.
Do not specify option /NOCS with any other chip select
There is a conflict in the command line.
Do not specify option /BYTE-MODE. Flash device does not have a byte
mode pin.
The flash device specified with the option /DEVICE= does not support
switching between 16 (or 32) bit mode and 8 bit mode. In practice it does not
have a pin with the name BYTE#
Error creating file:
The output file could not be opened. Please check free disk space or write
protection.
Error: Pin-Name is an output only pin
The specified pin cannot be sampled. Check the command line. Check the
initialization file.
Error Messages
JTAG_ADSP-21xxxa.doc