ZU-1890M Panasonic - ATG, ZU-1890M Datasheet
ZU-1890M
Specifications of ZU-1890M
ZU1890M
Related parts for ZU-1890M
ZU-1890M Summary of contents
Page 1
...
Page 2
INTRODUCTION----------------------------------------------------------------------------------------------------------------------1 2. PRODUCT NAME --------------------------------------------------------------------------------------------------------------------1 3. FUNCTION -----------------------------------------------------------------------------------------------------------------------------1 4. EQUIPMENT SPECIFICATION --------------------------------------------------------------------------------------------------1 5. BASIC FEATURES-------------------------------------------------------------------------------------------------------------------1 6. CARD SPECIFICATION ------------------------------------------------------------------------------------------------------------2 7. CIRCUIT CONSTRUCTION-------------------------------------------------------------------------------------------------------3 8. ENVIRONMENTAL CHARACTERISTICS ------------------------------------------------------------------------------------5 9. UNIT LIFE AND RELIABILITY ----------------------------------------------------------------------------------------------------6 10. GUARANTEE --------------------------------------------------------------------------------------------------------------------------6 11. MAINTENANCE-----------------------------------------------------------------------------------------------------------------------6 12. CAUTIONS ...
Page 3
... Magnetic head (1)Numbers of channel (2)Core width (3)Core material 5.3 Insulation resistance : Manual insertion type magnetic card reader : ZU-1890M : One way (Refer to Appearance) : Read only : Horizontal direction : (W) 101.6 mm × (D) 112.6 mm × (H) 76 Approximately 115 (tolerance ±10%) / Ripple (Less than 50 mV p-p) : TYP ...
Page 4
CARD SPECIFICATION 6.1 Card standard Materials and dimensions of the card should be submitted to ISO standards. But defined items in this specification are prior to these standards. Card Standard Recording density Recording capacity Recording method 6.2 Location of ...
Page 5
CIRCUIT CONSTRUCTION 7.1 Block diagram Photo Sensor Card detect Circuit Magnetic Head Fig 7.1 Block diagram 7.2 Interface requirement (1) Signal Level (2) Signal Logic (3) Connection condition CMOS (Card Reader side) Fig 7.2 Connection of ...
Page 6
Explanation of output signal Output signals are /CLD, /RCL1,2, /RDT1,2, /PH1 and effective operation mode for each of these signals shall be ”L” level for all. (1) /CLD : The /CLD will be Low when a Magnetic Card is ...
Page 7
Model No. Connector Housing Terminal (3) Pin No. & Signal Name (Card reader side) Connector Pin No Note) : Make sure to use the connection cable of less than 300 mm length for ...
Page 8
UNIT LIFE AND RELIABILITY 9.1 Life Magnetic head (conditions clean office room. In damp or dirty atmosphere, the life may be 1/3 to 1/5 of the above figure. 9.2 Error rate (conditions) This error rate is obtained ...
Page 9
At the use (1) Be sure to use a card, which conforms ISO standard. Anti-magnetic of the applied card should be 2.4×10 (2) Card operation speed should be within the specification range. Forced stop or change of speed during ...
Page 10
APPEARANCE - 8 - ...