ATMEGA48V-10MU Atmel, ATMEGA48V-10MU Datasheet - Page 38
Manufacturer Part Number
IC AVR MCU 4K 10MHZ 1.8V 32-QFN
Specifications of ATMEGA48V-10MU
I²C, SPI, UART/USART
Brown-out Detect/Reset, POR, PWM, WDT
Number Of I /o
Program Memory Size
4KB (2K x 16)
Program Memory Type
256 x 8
512 x 8
Voltage - Supply (vcc/vdd)
1.8 V ~ 5.5 V
-40°C ~ 85°C
Package / Case
32-VQFN Exposed Pad, 32-HVQFN, 32-SQFN, 32-DHVQFN
Operating Supply Voltage
Data Bus Width
Number Of Programmable I/os
Number Of Timers
Data Ram Size
Maximum Clock Frequency
Maximum Operating Temperature
+ 85 C
3rd Party Development Tools
Minimum Operating Temperature
- 40 C
No. Of I/o's
Eeprom Memory Size
Ram Memory Size
No. Of Timers
For Use With
ATSTK600-TQFP32 - STK600 SOCKET/ADAPTER 32-TQFPATSTK600-DIP40 - STK600 SOCKET/ADAPTER 40-PDIP770-1007 - ISP 4PORT ATMEL AVR MCU SPI/JTAGATAVRDRAGON - KIT DRAGON 32KB FLASH MEM AVRATAVRISP2 - PROGRAMMER AVR IN SYSTEMATJTAGICE2 - AVR ON-CHIP D-BUG SYSTEM
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
9. Power Management and Sleep Modes
Sleep modes enable the application to shut down unused modules in the MCU, thereby saving
power. The AVR provides various sleep modes allowing the user to tailor the power consump-
tion to the application’s requirements.
Figure 8-1 on page 26
distribution. The figure is helpful in selecting an appropriate sleep mode.
different sleep modes and their wake up sources.
To enter any of the five sleep modes, the SE bit in SMCR must be written to logic one and a
SLEEP instruction must be executed. The SM2, SM1, and SM0 bits in the SMCR Register select
which sleep mode (Idle, ADC Noise Reduction, Power-down, Power-save, or Standby) will be
activated by the SLEEP instruction. See
If an enabled interrupt occurs while the MCU is in a sleep mode, the MCU wakes up. The MCU
is then halted for four cycles in addition to the start-up time, executes the interrupt routine, and
resumes execution from the instruction following SLEEP. The contents of the Register File and
SRAM are unaltered when the device wakes up from sleep. If a reset occurs during sleep mode,
the MCU wakes up and executes from the Reset Vector.
When the SM2..0 bits are written to 000, the SLEEP instruction makes the MCU enter Idle
mode, stopping the CPU but allowing the SPI, USART, Analog Comparator, ADC, 2-wire Serial
Interface, Timer/Counters, Watchdog, and the interrupt system to continue operating. This sleep
mode basically halts clk
1. Only recommended with external crystal or resonator selected as clock source.
2. If Timer/Counter2 is running in asynchronous mode.
3. For INT1 and INT0, only level interrupt.
Active Clock Domains and Wake-up Sources in the Different Sleep Modes.
Active Clock Domains
presents the different clock systems in the ATmega48/88/168, and their
, while allowing the other clocks to run.
Table 9-2 on page 42
for a summary.