MC908AP32CFAE Freescale Semiconductor, MC908AP32CFAE Datasheet - Page 71

• Manufacturer Part Number: MC908AP32CFAE
• Description: IC MCU 32K FLASH 8MHZ 48-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC908AP32CFAE

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: I²C, IRSCI, SCI, SPI
• Peripherals: LED, LVD, POR, PWM
• Number Of I /o: 32
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-LQFP
• Controller Family/series: HC08
• No. Of I/o's: 32
• Ram Memory Size: 2KB
• Cpu Speed: 8MHz
• No. Of Timers: 2
• Embedded Interface Type: I2C, SCI, SPI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Chapter 5
Oscillator (OSC)
5.1 Introduction
The oscillator module consist of three types of oscillator circuits:
The reference clock for the CGM and other MCU sub-systems is selected by programming the mask
option register located at $FFCF.
The reference clock for the timebase module (TBM) is selected by the two bits, OSCCLK1 and OSCCLK0,
in the CONFIG2 register.
The internal oscillator runs continuously after a POR or reset, and is always available. The RC and crystal
oscillator cannot run concurrently; one is disabled while the other is selected; because the RC and x-tal
circuits share the same OSC1 pin.
Figure
5.2 Clock Selection
Reference clocks are selectable for the following sub-systems:
Freescale Semiconductor
•
•
•
•
•
Internal oscillator
RC oscillator
1MHz to 8MHz crystal (x-tal) oscillator
CGMXCLK and CGMRCLK — Reference clock for clock generator module (CGM) and other MCU
sub-systems other than TBM and COP. This is the main reference clock for the MCU.
OSCCLK — Reference clock for timebase module (TBM).
5-1. shows the block diagram of the oscillator module.
The oscillator circuits are powered by the on-chip V
therefore, the output swing on OSC1 and OSC2 is from V
MC68HC908AP A-Family Data Sheet, Rev. 3
NOTE
REG
regulator,
SS
to V
REG
.
71