ATMEGA16HVA-4TU Atmel, ATMEGA16HVA-4TU Datasheet - Page 158

• Manufacturer Part Number: ATMEGA16HVA-4TU
• Description: MCU AVR 16K FLASH 4MHZ 28-TSOP
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA16HVA-4TU

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 4MHz
• Connectivity: SPI
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 7
• Program Memory Size: 16KB (8K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 9 V
• Data Converters: A/D 5x12b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 28-TSOP
• For Use With: ATSTK600 - DEV KIT FOR AVR/AVR32ATSTK500 - PROGRAMMER AVR STARTER KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

27.8.3
27.8.4
158
ATmega8HVA/16HVA
Chip Erase
Programming the Flash
The Chip Erase will erase the Flash and EEPROM
not reset until the Program memory has been completely erased. The Fuse bits are not
changed. A Chip Erase must be performed before the Flash and/or EEPROM are re-
programmed.
Note:
1. Load command “Chip Erase” (see
2. Wait after Instr.3 until SDO goes high for the “Chip Erase” cycle to finish.
3. Load Command “No Operation”.
The Flash is organized in pages, see
the program data is latched into a page buffer. This allows one page of program data to be pro-
grammed simultaneously. The following procedure describes how to program the entire Flash
memory:
1. Load Command “Write Flash” (see
2. Load Flash Page Buffer.
3. Load Flash High Address and Program Page. Wait after Instr. 3 until SDO goes high for
4. Repeat 2 through 3 until the entire Flash is programmed or until all data has been
5. End Page Programming by Loading Command “No Operation”.
When writing or reading serial data to the ATmega8HVA/16HVA, data is clocked on the rising
edge of the serial clock, see
page 173
Figure 27-4. Addressing the Flash which is Organized in Pages
the “Page Programming” cycle to finish.
programmed.
1. The EEPROM memory is preserved during Chip Erase if the EESAVE Fuse is programmed.
for details.
PROGRAM MEMORY
PROGRAM
COUNTER
PAGE
PAGE ADDRESS
WITHIN THE FLASH
PCMSB
Figure
PCPAGE
27-5,
Table 27-10 on page
Table
Table
Figure 29-4
PAGEMSB
PCWORD
27-14).
27-14).
WORD ADDRESS
WITHIN A PAGE
(1)
memories plus Lock bits. The Lock bits are
and
INSTRUCTION WORD
”High-voltage Serial Programming” on
154. When programming the Flash,
PAGE
PCWORD[PAGEMSB:0]:
00
01
02
PAGEEND
8024A–AVR–04/08