ST10F276Z5Q3TR STMicroelectronics, ST10F276Z5Q3TR Datasheet - Page 70

• Manufacturer Part Number: ST10F276Z5Q3TR
• Description: MCU 16BIT 832KBIT FLASH 144-PQFP
• Manufacturer: STMicroelectronics
• Series: ST10r

Specifications of ST10F276Z5Q3TR

• Core Processor: ST10
• Core Size: 16-Bit
• Speed: 64MHz
• Connectivity: ASC, CAN, EBI/EMI, I²C, SSC, UART/USART
• Peripherals: POR, PWM, WDT
• Number Of I /o: 111
• Program Memory Size: 832KB (832K x 8)
• Program Memory Type: FLASH
• Ram Size: 68K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 24x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 144-QFP
• Processor Series: ST10F27x
• Core: ST10
• Data Bus Width: 16 bit
• Data Ram Size: 68 KB
• Interface Type: CAN, I2C
• Maximum Clock Frequency: 64 MHz
• Number Of Programmable I/os: 111
• Number Of Timers: 5
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 24 Channel
• For Use With: 497-6399 - KIT DEV STARTER ST10F276Z5
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

Bootstrap loader
5.7
70/239
Selective boot mode
The selective boot is a subcase of the Alternate Boot mode. When none of the signatures
are correct, instead of executing the standard bootstrap loader (triggered by P0L.4 low at
reset), an additional check is made.
Address 00’1FFCh is read again with the following behavior:
●
●
Table 38.
Therefore a value:
●
●
●
●
0
1
2..7
If value is 0000h or FFFFh, a jump is performed to the standard bootstrap loader.
Otherwise:
–
–
0xXX03 configures the Selective Bootstrap Loader to poll for RxD0 and CAN1_RxD.
0xXX01 configures the Selective Bootstrap Loader to poll only RxD0 (no boot via CAN).
0xXX02 configures the Selective Bootstrap Loader to poll only CAN1_RxD (no boot via
UART).
Other values allow the ST10F276Z5 to execute an endless loop into the Test-Flash.
Bit
High byte is disregarded.
Low byte bits select which communication channel is enabled.
Selective boot
UART selection
‘0’: UART is not watched for a Start condition.
‘1’: UART is watched for a Start condition.
CAN1 selection
‘0’: CAN1 is not watched for a Start condition.
‘1’: CAN1 is watched for a Start condition.
Reserved
For upward compatibility, must be programmed to ‘0’
Function
ST10F276Z5