DF2148RTE20IV Renesas Electronics America, DF2148RTE20IV Datasheet - Page 193

• Manufacturer Part Number: DF2148RTE20IV
• Description: MCU 5V 128K I-TEMP,PB-FREE, 100-
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2148RTE20IV

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: Host Interface, I²C, IrDA, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

The above contention will not occur if an enable bit or interrupt source flag is cleared to 0 while
the interrupt is masked.
5.6.2
Instructions that disable interrupts are LDC, ANDC, ORC, and XORC. After any of these
instructions is executed, all interrupts except NMI are disabled and the next instruction is always
executed. When the I bit or UI bit is set by one of these instructions, the new value becomes valid
two states after execution of the instruction ends.
5.6.3
Interrupt operation differs between the EEPMOV.B instruction and the EEPMOV.W instruction.
With the EEPMOV.B instruction, an interrupt request (including NMI) issued during the transfer
is not accepted until the move is completed.
With the EEPMOV.W instruction, if an interrupt request is issued during the transfer, interrupt
exception handling starts at a break in the transfer cycle. The PC value saved on the stack in this
case is the address of the next instruction.
Therefore, if an interrupt is generated during execution of an EEPMOV.W instruction, the
following coding should be used.
L1:
Instructions That Disable Interrupts
Interrupts during Execution of EEPMOV Instruction
EEPMOV.W
MOV.W
BNE
R4,R4
L1
Rev. 4.00 Sep 27, 2006 page 147 of 1130
Section 5 Interrupt Controller
REJ09B0327-0400