UPD78F9222MC-5A4-A Renesas Electronics America, UPD78F9222MC-5A4-A Datasheet - Page 308

• Manufacturer Part Number: UPD78F9222MC-5A4-A
• Description: MCU 8BIT 4KB FLASH 20PIN
• Manufacturer: Renesas Electronics America
• Series: 78K0S/Kx1+r

Specifications of UPD78F9222MC-5A4-A

• Core Processor: 78K0S
• Core Size: 8-Bit
• Speed: 10MHz
• Connectivity: LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: FLASH
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

18.8.9 Example of internal verify operation in self programming mode
306
Examples of the internal verify 1 and 2 operations in self programming mode are explained below.
• Internal verify 1
<1> Set 01H (internal verify) to the flash program command register (FLCMD).
<2> Set the block number for which internal verify is performed, to flash address pointer H (FLAPH).
<3> Set 00H to the flash address pointer L (FLAPL).
<4> Write the same value as that of FLAPH to the flash address pointer H compare register (FLAPHC).
<5> Set FFH to the flash address pointer L compare register (FLAPLC).
<6> Clear the flash status register (PFS).
<7> Write ACH to the watchdog timer enable register (WDTE) (clear and restart the watchdog timer counter)
<8> Execute the HALT instruction then start self programming. (Execute an instruction immediately after the
<9> Check if a self programming error has occurred using bit 1 (VCERR) and bit 2 (WEPRERR) of PFS.
<10> Internal verify processing is terminated abnormally.
<11> Internal verify processing is terminated normally.
• Internal verify 2
<1> Set 02H (internal verify 2) to the flash program command register (FLCMD).
<2> Set the block number for which internal verify is performed, to flash address pointer H (FLAPH).
<3> Set the verify start address to the flash address pointer L (FLAPL).
<4> Write the same value as that of FLAPH to the flash address pointer H compare register (FLAPHC).
<5> Set the verify end address to the flash address pointer L compare register (FLAPLC).
<6> Clear the flash status register (PFS).
<7> Write ACH to the watchdog timer enable register (WDTE) (clear and restart the watchdog timer counter)
<8> Execute the HALT instruction then start self programming. (Execute an instruction immediately after the HALT
<9> Check if a self programming error has occurred using bit 1 (VCERR) and bit 2 (WEPRERR) of PFS.
<10> Internal verify processing is terminated abnormally.
<11> Internal verify processing is terminated normally.
Note This setting is not required when the watchdog timer is not used.
HALT instruction if self programming has been executed.)
Abnormal
Normal
instruction if self programming has been executed.)
Abnormal
Normal
<10>
<11>
<10>
<11>
CHAPTER 18 FLASH MEMORY
User’s Manual U16898EJ6V0UD
Note
Note
.
.