WS2411-BLK Avago Technologies US Inc., WS2411-BLK Datasheet - Page 11

• Manufacturer Part Number: WS2411-BLK
• Description: MODULE PA UMTS1900 4X4MM 10-PIN
• Manufacturer: Avago Technologies US Inc.
• Type: Power Amplifierr

Specifications of WS2411-BLK

• Package / Case: 10-DFN
• Current - Supply: 500mA ~ 550mA
• Frequency: 1.85GHz ~ 1.91GHz
• Gain: 24dB ~ 27dB
• Rf Type: W-CDMA, HSPDA
• Voltage - Supply: 3.2V ~ 4.2V
• Operating Frequency: 1910 MHz
• Operating Supply Voltage: 4.2 V
• Supply Current: 550 mA
• Maximum Operating Temperature: + 90 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 20 C
• Number Of Channels: 1 Channel
• Frequency (max): 1.91GHz
• Power Supply Requirement: Dual
• Single Supply Voltage (min): Not RequiredV
• Single Supply Voltage (typ): Not RequiredV
• Single Supply Voltage (max): Not RequiredV
• Package Type: SMD
• Dual Supply Voltage (min): 3.2/3.2V
• Dual Supply Voltage (typ): 3.4V
• Dual Supply Voltage (max): 4.2V
• Operating Temperature Classification: Commercial
• Operating Temp Range: -20C to 90C
• Pin Count: 10
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Noise Figure: -
• P1db: -
• Test Frequency: -
• Lead Free Status / Rohs Status: Compliant

11
Peripheral Circuit in Handset
Figure 21. Peripheral Circuit.
Notes:
1. Recommended voltage for Vref is 2.85V.
2. Place C1 near to Vref pin.
3. Place C3 and C4 close to pin 1 (Vcc1) and pin 10 (Vcc2). These capacitors can affect the RF performance.
4. Use 50Ω transmission line between PAM and Duplexer and make it as short as possible to reduce conduction loss.
5. π-type circuit topology is good to use for matching circuit between PA and Duplexer,.
6. Pull-up resistor (R1) should be used to limit current drain. 6.2 kohm is recommended for WS2411.
MSM
RF In
PA_ON
PA_R0
Vdd
RF SAW
R1
C2
+2.85V
C3
C1
IN
GND
Vcc1
Vcont
Vref
WS2411
C8
V
Vcc2
GND
GND
OUT
GND
BATT
C4
C5
Output Matching Circuit
C7
C6
L1
Duplexer
RF Out