101-1268 Rabbit Semiconductor, 101-1268 Datasheet - Page 101

• Manufacturer Part Number: 101-1268
• Description: KIT FOR BL4S100 STARTER PACKAGE
• Manufacturer: Rabbit Semiconductor
• Type: Single Board Computers (SBC)r

Specifications of 101-1268

• Product: Modules
• Processor Type: BL4S100
• Sram: 512 KB
• Timers: 8 bit, 10 bit
• Number Of I/os: 20
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 9 V to 36 V
• Power Consumption: 2 W
• Board Size: 96 mm x 146 mm x 16 mm
• Description/function: Computer Module
• For Use With/related Products: BL4S100
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1157

5.2.3 Run the PINGME.C Demo
Connect the crossover cable from your computer’s Ethernet port to the BL4S100’s RJ-45
Ethernet connector. Open this sample program from the
compile the program, and start it running under Dynamic C. When the program starts run-
ning, the green
is made. (Note: If the
you are using a hub perhaps the power is off on the hub.)
The next step is to ping the board from your PC. This can be done by bringing up the MS-
DOS window and running the ping program:
or by
and typing the command
Notice that the orange
taking place, and indicates the transfer of data. The ping routine will ping the board four
times and write a summary message on the screen describing the operation.
BL4S100 User’s Manual
Start
ping 10.10.6.100
ping 10.10.6.100
>
Run
LNK
light on the BL4S100 should be on to indicate an Ethernet connection
LNK
ACT
light does not light, you may not have a crossover cable, or if
light flashes on the BL4S100 Ethernet jack while the ping is
SAMPLES\TCPIP\ICMP
folder,
99