101-1268 Rabbit Semiconductor, 101-1268 Datasheet - Page 75

• Manufacturer Part Number: 101-1268
• Description: KIT FOR BL4S100 STARTER PACKAGE
• Manufacturer: Rabbit Semiconductor
• Type: Single Board Computers (SBC)r

Specifications of 101-1268

• Product: Modules
• Processor Type: BL4S100
• Sram: 512 KB
• Timers: 8 bit, 10 bit
• Number Of I/os: 20
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 9 V to 36 V
• Power Consumption: 2 W
• Board Size: 96 mm x 146 mm x 16 mm
• Description/function: Computer Module
• For Use With/related Products: BL4S100
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1157

FUNCTION DESCRIPTION
PARAMETERS
RETURN VALUE
SEE ALSO
BL4S100 User’s Manual
int setSyncOut(int channel, int source, int edge);
brdInit, setSyncIn
Sets the synch for the block the digital output channel is associated with.
Note that when more than one block is synchronized to the same synch signal (global
or external), each block has its own independent edge-detection circuit. These circuits
will synch to the edge within plus or minus one count of the block’s current clock
source (main or prescale). This means synchronized blocks may have a small offset
when compared to each other.
channel
source
edge
0 — success.
-EINVAL
-EPERM
-EACCES
-EFAULT
— pin type does not permit this function.
— invalid parameter value.
— resource needed by this function is not available.
— internal data fault detected.
digital output channel that is on the block that will have its synch
set, 0–7 (OUT0–OUT7)
source of the synch signal.
edge of the synch signal.
-1 to use the RIO chip's Global Synch signal or
input-capable channel to use as an external synch signal
BL_EDGE_RISE
BL_EDGE_FALL
BL_EDGE_BOTH
0
— disable the synch on this block (if the source of the external
synch is given, it will be set to a digital input)
setSyncOut
— synchronize event on rising edge
— synchronize event on falling edge
— synchronize events on both edges
73