101-1272 Rabbit Semiconductor, 101-1272 Datasheet - Page 65

• Manufacturer Part Number: 101-1272
• Description: KIT MESH NETWORK ADD-ON RCM4510W
• Manufacturer: Rabbit Semiconductor
• Type: Microprocessorr

Specifications of 101-1272

• Product: Modules
• Data Bus Width: 12 bit
• Processor Type: Rabbit 4000
• Sram: 512 KB
• Number Of I/os: 20
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: RCM4510W
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1158

6.2 ZigBee Sample Programs
In order to run the sample programs discussed in this chapter and elsewhere in this manual,
1. Your module must be plugged into the Prototyping Board as described in Chapter 2,
2. Dynamic C must be installed and running on your PC.
3. The programming cable must connect the programming header on the RCM4510W to
4. Power must be applied to the module through the Prototyping Board.
5. The Digi
Refer to Chapter 2, “Getting Started,” if you need further information on these steps.
To run a sample program, open it with the
and run it by pressing
Each sample program has comments that describe the purpose and function of the pro-
gram. Follow the instructions at the beginning of the sample program.
The sample programs in the Dynamic C
folders illustrate the use of the XBee function calls.
6.2.1 Setting Up the Digi XBee USB Coordinator
1. Connect the Digi
2. Compile and run the
3. Open the ZigBee Utility by double-clicking
4. Confirm the following hardware setup is displayed on the “PC Settings” tab.
User’s Manual
“Getting Started.”
your PC.
able USB port on your PC if you are exercising the ZigBee protocol, or you need a
second RCM4510W module if so instructed.
on your PC or workstation. Your PC should recognize the new USB hardware.
SAMPLES\RCM4500W\XBee
Utilities\XBee GPIO GUI
Utility, install a .Net Framework by double-clicking
Utilities\dotnetfx
desktop.
®
XBee USB used as the ZigBee coordinator must be connected to an avail-
®
XBee USB acting as a ZigBee coordinator to an available USB port
F9
XBEE_GPIO_SERVER.C
•
•
•
•
•
.
115200 baud
Hardware flow control
8 data bits
No parity
1 stop bit
folder. You may add a shortcut to the ZigBee Utility on your
folder.
folder — if you have problems launching the ZigBee
SAMPLES\RCM4500W\XBee
File
XBEE_GPIO_GUI.exe
menu (if it is not still open), then compile
sample program in the Dynamic C
dotnetfx.exe
and
in the Dynamic C
in the Dynamic C
SAMPLES\XBee
59