TEF6721HL/V1S,518 NXP Semiconductors, TEF6721HL/V1S,518 Datasheet - Page 8

• Manufacturer Part Number: TEF6721HL/V1S,518
• Description: IC FRONT END DGTL CAR RAD 64LQFP
• Manufacturer: NXP Semiconductors

Specifications of TEF6721HL/V1S,518

• Modulation Or Protocol: AM, FM, WB
• Applications: AM/FM Radio Receiver
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 5V, 8.5V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Frequency: -
• Sensitivity: -
• Memory Size: -
• Data Rate - Maximum: -
• Current - Receiving: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 935288831518

Philips Semiconductors
TEF6721HL_4
Product data sheet
7.5 PLL
7.6 DAA
The fast synthesizer PLL tuning system with local control is used for inaudible AF
updating, combining fast PLL jumps with low reference frequency breakthrough.
It is capable of tuning the following FM and AM bands:
To reduce the number of manual alignments in production, the following I
Digital Auto Alignment (DAA) functions are included:
Fig 3. Crystal oscillator with frequency pulling
•
•
•
•
•
•
•
•
•
•
US FM and US IBOC DAB from 87.9 MHz to 107.9 MHz
US weather FM from 162.4 MHz to 162.55 MHz
Europe FM from 87.5 MHz to 108 MHz
Japan FM from 76 MHz to 91 MHz
East Europe FM from 64 MHz to 74 MHz
LW from 144 kHz to 288 kHz
MW from 522 kHz to 1710 kHz (US AM band)
SW from 5.73 MHz to 9.99 MHz (including the 31 m, 41 m and 49 m bands).
FM RF DAA
– 7-bit DAC to control the conversion of the VCO tuning voltage to FM antenna tank
– For cost reduction the diode at pin DAATD can be omitted from this application. In
Crystal frequency and general purpose DAA
– 5-bit DAC for adjustment of the crystal oscillator frequency to align the actual IF
tuning voltage
this case, pin DAATD must be connected to ground, which reduces the available
alignment range (see
frequency to the center frequency of IF selectivity inside the IF DSP. If the IF DSP
can be aligned to the actual IF frequency, this DAA output can be used as general
purpose DAC.
frequency pulling.
Rev. 04 — 20 December 2005
Figure 3
OSCILLATOR
CRYSTAL
CRYSTAL
DAA
Figure
shows the application of the crystal oscillator with
9)
60
59
58
57
2.7 pF
1 nF
Car radio tuner front-end for digital IF
20.5 MHz
100
k
BB201
100
k
22 nF
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
mdb413
TEF6721HL
2
C-bus controlled
8 of 48