20-101-1265 Rabbit Semiconductor, 20-101-1265 Datasheet - Page 27

• Manufacturer Part Number: 20-101-1265
• Description: MODULE MINICORE RCM5600W
• Manufacturer: Rabbit Semiconductor
• Series: MiniCore™r

Specifications of 20-101-1265

• Frequency: 2.4GHz
• Modulation Or Protocol: 802.11 b/g
• Applications: General Purpose
• Voltage - Supply: 3.15 V ~ 3.45 V
• Current - Receiving: 625mA
• Current - Transmitting: 625mA
• Data Interface: Connector, Mini PCI express
• Memory Size: 1 MB Flash, 1MB SRAM
• Antenna Connector: U.FL
• Operating Temperature: -30°C ~ 55°C
• Package / Case: Module
• Wireless Frequency: 2.4 GHz
• Security: 64/128 bit WEP
• Operating Voltage: 3.3 V
• Antenna: U.FL Connector
• Operating Temperature Range: - 30 C to + 55 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Sensitivity: -
• Data Rate - Maximum: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Rabbit 5000
• Other names: 316-1174

The Digital I/O accessory board may also be used to run the
SERIALTOSERIAL.C
Deluxe Development Kit.
To install the Digital I/O accessory board, insert the strip of header pins included with the
accessory board into the socket at J12 on the bottom side of the Digital I/O accessory
board. Then line up the Digital I/O accessory board with the Interface Board standoffs/
connectors and install the Digital I/O accessory board pins into socket J2 on the Interface
Board. Secure the Digital I/O accessory board with the long plastic standoffs/connectors
from above as shown in Figure 6—note that one plastic standoff/connector needs to be
inserted “upside down” to secure the Digital I/O accessory board to the antenna bracket.
Pins 1–2, 3–4, 5–6, and 7–8 on headers JP5 and JP8 on the Digital I/O accessory board
must be jumpered. Pins 2–4 and 3–5 on header JP7 on the Digital I/O accessory board
must also be jumpered.
Uncomment the following line in the sample programs when you are using the Digital I/O
accessory board.
•
OEM User’s Manual
TOGGLESWITCH.C
sory board and lights LEDs DS1–DS4 when the corresponding pushbutton switch is
pressed. LEDs DS1–DS2 on the Digital I/O accessory board are controlled by PA4–
PA7, and switches S1–S4 are controlled by PB4–PB7 respectively.
#define DIGITAL_IO_ACCESSORY
—monitors switches S1, S2, S3, and S4 on the Digital I/O acces-
sample programs. This accessory board is included only with the
Figure 6. Install Digital I/O Accessory Board
TOGGLESWITCH.C
and the
21