20-101-1265 Rabbit Semiconductor, 20-101-1265 Datasheet - Page 61

• Manufacturer Part Number: 20-101-1265
• Description: MODULE MINICORE RCM5600W
• Manufacturer: Rabbit Semiconductor
• Series: MiniCore™r

Specifications of 20-101-1265

• Frequency: 2.4GHz
• Modulation Or Protocol: 802.11 b/g
• Applications: General Purpose
• Voltage - Supply: 3.15 V ~ 3.45 V
• Current - Receiving: 625mA
• Current - Transmitting: 625mA
• Data Interface: Connector, Mini PCI express
• Memory Size: 1 MB Flash, 1MB SRAM
• Antenna Connector: U.FL
• Operating Temperature: -30°C ~ 55°C
• Package / Case: Module
• Wireless Frequency: 2.4 GHz
• Security: 64/128 bit WEP
• Operating Voltage: 3.3 V
• Antenna: U.FL Connector
• Operating Temperature Range: - 30 C to + 55 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Sensitivity: -
• Data Rate - Maximum: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Rabbit 5000
• Other names: 316-1174

6.2.3.2 PC/Laptop/PDA Configuration
This section shows how to configure your PC or notebook to run the sample programs.
Here we’re mainly interested in the PC or notebook that will be communicating wirelessly,
which is not necessarily the PC that is being used to compile and run the sample program
on the RCM5600W module.
When you are using an access point with your setup in the infrastructure mode, you will also
have to set the IP address and netmask (e.g., 10.10.6.99 and 255.255.255.0) for the access
point. Check the documentation for the access point for information on how to do this.
Infrastructure Mode (via Ethernet connection)
OEM User’s Manual
This section provides configuration
information for the three possible Wi-Fi
setups shown in Figure 12. Start by
going to the control panel (
Settings > Control Panel
Network Connections
shots shown here are from Windows
2000, and the interface is similar for
other versions of Windows.
Check with your administrator if you are
unable to change the settings as
described here since you may need
administrator privileges.
1. Go to the
select the network interface card used you
intend to use (e.g.,
Card Network Adapter
“Properties” button. Depending on which
version of Windows your PC is running,
you may have to select the “Local Area
Connection” first, and then click on the
“Properties” button to bring up the Ether-
net interface dialog. Then “configure”
your interface card for an “Auto-Negotia-
tion” or “10Base-T Half-Duplex” connec-
tion on the “Advanced” tab.
NOTE: Your network interface card will
likely have a different name.
Local Area Connection
TCP/IP Xircom Credit
. The screen
) and click on
Start >
) and click on the
to
55