ATMEGA2561R231-MU Atmel, ATMEGA2561R231-MU Datasheet - Page 195

• Manufacturer Part Number: ATMEGA2561R231-MU
• Description: BUNDLE ATMEGA2561/RF231 QFN
• Manufacturer: Atmel

Specifications of ATMEGA2561R231-MU

• Frequency: 2.4GHz
• Modulation Or Protocol: 802.15.4 Zigbee, 6LoWPAN, RF4CE, SP100, WirelessHART™, ISM
• Data Interface: PCB, Surface Mount
• Memory Size: 256kB Flash, 4kB EEPROM, 8kB RAM
• Antenna Connector: PCB, Surface Mount
• Package / Case: 64-QFN, 32-QFN
• Processor Series: ATMEGA256x
• Core: AVR8
• Data Bus Width: 8 bit
• Program Memory Type: Flash
• Program Memory Size: 256 KB
• Data Ram Size: 8 KB
• Development Tools By Supplier: ATAVRRZ541, ATAVRRAVEN, ATAVRRZUSBSTICK, ATAVRISP2, ATAVRRZ201
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply: -
• Power - Output: -
• Operating Temperature: -
• Applications: -
• Sensitivity: -
• Data Rate - Maximum: -
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Details

20. SPI – Serial Peripheral Interface
2549M–AVR–09/10
The Serial Peripheral Interface (SPI) allows high-speed synchronous data transfer between the
ATmega640/1280/1281/2560/2561 and peripheral devices or between several AVR devices.
The ATmega640/1280/1281/2560/2561 SPI includes the following features:
•
•
•
•
•
•
•
•
USART can also be used in Master SPI mode, see
The Power Reduction SPI bit, PRSPI, in
page 50 must be written to zero to enable SPI module.
Figure 20-1. SPI Block Diagram
Note:
The interconnection between Master and Slave CPUs with SPI is shown in
196. The system consists of two shift Registers, and a Master clock generator. The SPI Master
initiates the communication cycle when pulling low the Slave Select SS pin of the desired Slave.
Full-duplex, Three-wire Synchronous Data Transfer
Master or Slave Operation
LSB First or MSB First Data Transfer
Seven Programmable Bit Rates
End of Transmission Interrupt Flag
Write Collision Flag Protection
Wake-up from Idle Mode
Double Speed (CK/2) Master SPI Mode
1. Refer to
/2/4/8/16/32/64/128
DIVIDER
Figure 1-1 on page
ATmega640/1280/1281/2560/2561
(1)
2, and
“PRR0 – Power Reduction Register 0” on page 56
Table 12-6 on page 79
“USART in SPI Mode” on page
for SPI pin placement.
Figure 20-2 on page
232.
195
on