STLM75M2E STMicroelectronics, STLM75M2E Datasheet - Page 7

• Manufacturer Part Number: STLM75M2E
• Description: IC TEMP SENSOR DIGITAL SO-8
• Manufacturer: STMicroelectronics

Specifications of STLM75M2E

• Featured Product: STM32 Cortex-M3 Companion Products
• Function: Temp Sensor, Watchdog
• Topology: ADC (Sigma Delta), Comparator, Register Bank
• Sensor Type: Internal
• Sensing Temperature: -55°C ~ 125°C
• Output Type: I²C™/SMBus™
• Output Alarm: Yes
• Output Fan: No
• Voltage - Supply: 2.7 V ~ 5.5 V
• Operating Temperature: -55°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (0.154", 3.90mm Width)
• Full Temp Accuracy: +/- 3 C
• Digital Output - Bus Interface: Serial (2-Wire, I2C)
• Digital Output - Number Of Bits: 9 bit
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 55 C
• Ic Output Type: Digital
• Sensing Accuracy Range: ± 0.5°C
• Temperature Sensing Range: -55°C To +125°C
• Supply Current: 125µA
• Supply Voltage Range: 2.7V To 5.5V
• Sensor Case Style: SOIC
• No. Of Pins: 8
• Rohs Compliant: Yes
• For Use With: 497-10508 - BOARD EVAL FOR MEMS SENSORS497-10048 - BOARD EVAL ACCELEROMETER497-6238 - BOARD STLM75/STDS75/ST72F651
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

STLM75
1.2
Note:
Temperature sensor output
The STLM75 temperature sensor has a dedicated open drain overlimit signal/interrupt
(OS/INT) output which features a thermal alarm function. This function provides a user-
programmable trip and turn-off temperature. It can operate in either of two selectable
modes:
●
●
At power-up the STLM75 immediately begins measuring the temperature and converting
the temperature to a digital value.
The measured temperature value is compared with a temperature limit (which is stored in
the 16-bit (T
the 16-bit (T
OS/INT pin is activated (see
See
Figure 1.
1. SDA and OS/INT are open drain.
Pin descriptions on page 9
Comparator
Interrupt
OS
HYS
Logic diagram
mode.
) READ/WRITE register), and the hysteresis temperature (which is stored in
) READ/WRITE register). If the measured value exceeds these limits, the
mode, and
SDA
SCL
Figure 3 on page 8
A 0
A 1
A 2
Doc ID 13296 Rev 12
(1)
for details.
STLM75
V DD
GND
and
Table 2 on page
OS/INT
(1)
14).
Description
AI11899
7/40