S-1142A50I-E6T1U Seiko Instruments, S-1142A50I-E6T1U Datasheet - Page 18
![no-image](/images/manufacturer_photos/0/5/590/seiko_instruments_sml.jpg)
S-1142A50I-E6T1U
Manufacturer Part Number
S-1142A50I-E6T1U
Description
IC REG LDO 5V 0.2A HSOP6
Manufacturer
Seiko Instruments
Datasheet
1.S-1142B33I-E6T1U.pdf
(35 pages)
Specifications of S-1142A50I-E6T1U
Regulator Topology
Positive Fixed
Voltage - Output
5V
Voltage - Input
Up to 50V
Voltage - Dropout (typical)
0.5V @ 200mA
Number Of Regulators
1
Current - Output
200mA (Min)
Operating Temperature
-40°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
6-SOIC variation (0.154", 3.9mm), 4 Leads + 2 Fins
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Current - Limit (min)
-
Other names
728-1060-2
18
HIGH-WITHSTAND VOLTAGE LOW CURRENT CONSUMPTION LOW DROPOUT CMOS VOLTAGE REGULATOR
S-1142 Series
Precautions
• Wiring patterns for the VIN, VOUT and GND pins should be designed so that the impedance is low. When mounting
• Note that the output voltage may generally increase when a series regulator is used at low load current (0.1 mA or
• Note that the output voltage may generally increase due to the leakage current from a driver when a series regulator
• Note that the output voltage may increase due to the leakage current from a driver even if the ON/OFF pin is at the
• Generally series regulators may oscillate, depending on the selection of external parts. The following conditions are
• The voltage regulator may oscillate when the impedance of the power supply is high and the input capacitance of the
• It is important to sufficiently evaluate in an actual device output voltage fluctuations caused by power supply or load
• A momentary overshoot may be output when the power supply suddenly increases, and the output capacitance is
• The application conditions for the input voltage, output voltage, and load current should not exceed power dissipation
• Do not apply an electrostatic discharge to this IC that exceeds the performance ratings of the built-in electrostatic
• In determining the output current, attention should be paid to the output current value specified in Table 6 and Table
• SII claims no responsibility for any disputes arising out of or in connection with any infringement by products
an output capacitor between the VOUT and VSS pins (C
and VSS pins (C
less).
is used at a high temperature.
power-off level when a series regulator is used at a high temperature.
recommended for this IC. However, be sure to perform sufficient evaluation under the actual usage conditions for
selection, including the temperature characteristics. Regarding the equivalent series resistance (R
capacitor, refer to (6) Example of Equivalent Series Resistance vs. Output Current Characteristics (Ta = +25°C)
in “
IC is small, or an input capacitor is not connected.
fluctuations.
small. It is therefore important to sufficiently evaluate the output voltage at power application in actual device.
of the package.
protection circuit.
7 in “ Electrical Characteristics” and footnote *4 of the table.
including this IC of patents owned by a third party.
Input capacitor (C
Output capacitor (C
Reference Data”.
IN
), the distance from the capacitors to these pins should be as short as possible.
IN
) :
L
) : 0.1 μF or more
0.1 μF or more
Seiko Instruments Inc.
L
) and a capacitor for stabilizing the input between the VIN
ESR
) for the output
Rev.2.0
_00