STM32W108B-SK STMicroelectronics, STM32W108B-SK Datasheet - Page 10

• Manufacturer Part Number: STM32W108B-SK
• Description: STARTER KIT FOR STM32W108
• Manufacturer: STMicroelectronics
• Series: STM32r
• Type: MCUr

Specifications of STM32W108B-SK

• Featured Product: STM32 Cortex-M3 Companion Products
• Contents: Board
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: Cortex - M3
• Silicon Core Number: STM32
• Silicon Family Name: STM32W108xx
• Kit Contents: Board
• Features: IEEE
• Mfg Application Notes: STM32W108 Adjacent Channel Rejection Measurements
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: *
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Running the STM32W108xx kits
2
2.1
2.2
2.2.1
10/21
Running the STM32W108xx kits
STM32W-SK
In the STM32W-SK starter kit, the following applications are preprogrammed:
This allows you to immediately run the ZigBee PRO sink, sensor demonstration
applications, just by selecting the sink application on the STM32-Primer2 (see
Sink, sensor mesh network (based on ZigBee PRO)
packet capture session using the Perytons analyzer (see
more details).
STM32W-EXT
In the STM32W-EXT extension kit, all four boards are preprogrammed with EmberZNet
ZigBee PRO sensor firmware (MB851 board labeled as “Sensor”).
Using these boards, you can extend the sink, sensor mesh network with other four sensors
nodes.
Installing the STM32W108xx kit software tree
To install the specific kit software and documentation tree, download the related installer file
from http://www.st.com/mcu/, STM32W section. Then start the installation process on your
destination folder.
Sink, sensor mesh network (based on ZigBee PRO)
This section shows how to set up a mesh network with a ‘sink’ node which collects
information that come from several ‘sensor’ nodes.
Run preloaded sink appl. on STM32-Primer2, MB850 platforms
The STM32-Primer2 tool is delivered with the sink application preloaded. This application
automatically configures the connected MB850 extension board with the related ZigBee
PRO sink application.
To run the sink application on the STM32 Primer2 and MB850 boards, follow these steps:
1.
2.
3.
One EmberZNet ZigBee PRO sink firmware (MB850 board labeled as “Sink”)
Three CircleOs applications preloaded in the STM32-Primer2:
–
–
–
One EmberZNet ZigBee PRO sensor firmware (MB851 board labeled as “Sensor”)
One Perytons capture firmware (MB851 board labeled as “Analyzer”)
Connect the MB850 to the extension connector of the STM32-Primer2 tool.
Power on your STM32-Primer2.
Press the joystick button to launch the main menu and select Applic.->ZP SINK.
ZigBee PRO sink application
ZigBee RF4CE RC application
Simple MAC sun sample application
Doc ID 16999 Rev 2
for more details). You can also start a
Section 3.2: Network analyzer
Section 2.2:
UM0894
for