STM32W108B-SK STMicroelectronics, STM32W108B-SK Datasheet - Page 9

• Manufacturer Part Number: STM32W108B-SK
• Description: STARTER KIT FOR STM32W108
• Manufacturer: STMicroelectronics
• Series: STM32r
• Type: MCUr

Specifications of STM32W108B-SK

• Featured Product: STM32 Cortex-M3 Companion Products
• Contents: Board
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: Cortex - M3
• Silicon Core Number: STM32
• Silicon Family Name: STM32W108xx
• Kit Contents: Board
• Features: IEEE
• Mfg Application Notes: STM32W108 Adjacent Channel Rejection Measurements
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: *
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

UM0894
1.3
1.3.1
Note:
1.3.2
1.3.3
1
2
Kit setup
Powering on the boards
The MB851 application board can be powered as follows:
The jumper position 3-4 is reserved for internal usage.
To enable the MB851 board temperature sensor, MEMS and infrared, fit the jumper JP1.
The MB850 extension board has been designed as an IEEE 802.15.4 application-specific
daughter-board. It must be connected to the STM32-Primer2 extension connector to be
powered through the STM32-Primer2. The MB850 should be connected with the
STM32W108 visible.
Installing the FTDI USB drive
In order to use the serial communication channel on the MB851 board, a driver for the FTDI
USB<->Serial converter must be installed. This driver can be downloaded from the FTDI
website: http://www.ftdichip.com/Drivers/VCP.htm.
Setting up the application serial communication channel
To get full access to all the available commands, some demonstration applications may
require that the MB851 board is interfaced with the user through a serial communication
channel (virtual COM through USB). To set a serial communication channel for the MB851
board, follow these steps:
1.
2.
3.
4.
The STM32-Primer2 and MB850 demonstration applications use the STM32-Primer2
resources (LCD, joystick with button, touch screen display) as I/O communication channels.
Via batteries (fit 1-2 on the P2 jumper)
Via USB or JTAG (fit 5-6 on the P2 jumper)
Fit the MB851 jumper P2 on position 5-6 (power via USB).
Connect a mini USB cable to the MB851 mini USB connector and to a PC USB port.
Right-click on My Computer, select Manage, Device Manager, and open Ports (COM
& LPT) to display the related USB COMx port.
Open a hyper terminal on the corresponding USB virtual COMx port with the following
configuration:
–
–
–
–
–
Bit rate: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Doc ID 16999 Rev 2
Getting started
9/21