CS8415A-CS Cirrus Logic Inc, CS8415A-CS Datasheet - Page 41

IC, DIGITAL AUDIO RECEIVER, SOIC-28

CS8415A-CS

Manufacturer Part Number
CS8415A-CS
Description
IC, DIGITAL AUDIO RECEIVER, SOIC-28
Manufacturer
Cirrus Logic Inc
Datasheets

Specifications of CS8415A-CS

Audio Control Type
Digital
Control Interface
I2C, Serial
Control / Process Application
AV & DVD Receivers, CD-R, Digital Mixing Consoles
Supply Voltage Range
2.85V To 5.5V
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
CS8415A-CS
Manufacturer:
CIRRUS LOGIC
Quantity:
285
Part Number:
CS8415A-CS
Manufacturer:
CIRRUS
Quantity:
20 000
Company:
Part Number:
CS8415A-CS
Quantity:
2 557
Company:
Part Number:
CS8415A-CS
Quantity:
325
Part Number:
CS8415A-CSEP
Quantity:
200
Part Number:
CS8415A-CSR
Manufacturer:
CirrusLogic
Quantity:
569
Part Number:
CS8415A-CSZ
Manufacturer:
CIRRUS
Quantity:
108
Part Number:
CS8415A-CSZ
Manufacturer:
CRYSTAL
Quantity:
20 000
DS470F4
15.APPENDIX C: PLL FILTER
15.1 General
An on-chip Phase Locked Loop (PLL) is used to recover the clock from the incoming data stream.
is a simplified diagram of the PLL in these parts. When the PLL is locked to an AES3 input stream, it is up-
dated at each preamble in the AES3 stream. This occurs at twice the sampling frequency, F
PLL is locked to ILRCK, it is updated at F
There are some applications where low-jitter in the recovered clock, presented on the RMCK pin, is impor-
tant. For this reason, the PLL has been designed to have good jitter attenuation characteristics, as shown
in
preambles of the AES3 stream to provide lock update information to the PLL. This results in the PLL being
immune to data-dependent jitter affects because the AES3 preambles do not vary with the data.
The PLL has the ability to lock onto a wide range of input sample rates with no external component changes.
If the sample rate of the input subsequently changes, for example in a varispeed application, the PLL will
only track up to ±12.5% from the nominal center sample rate. The nominal center sample rate is the sample
rate that the PLL first locks onto upon application of an AES3 data stream or after enabling the CS8415A
clocks by setting the RUN control bit. If the 12.5% sample rate limit is exceeded, the PLL will return to its
wide lock range mode and re-acquire a new nominal center sample rate.
Figure
INPUT
21,
Figure
and Charge Pump
22,
Comparator
Phase
Figure
÷N
23, and
Figure 18. PLL Block Diagram
Figure
S
so that the duty cycle of the input doesn’t affect jitter.
24. In addition, the PLL has been designed to only use the
C
R
FLT
FLT
C
RIP
VCO
RMCK
CS8415A
S
. When the
Figure 18
41

Related parts for CS8415A-CS