DP83848HSQ National Semiconductor, DP83848HSQ Datasheet - Page 40
DP83848HSQ
Manufacturer Part Number
DP83848HSQ
Description
IC, TRANSCEIVER, ENET PHYTER, 40LLP
Manufacturer
National Semiconductor
Datasheet
1.DP83848HSQ.pdf
(80 pages)
Specifications of DP83848HSQ
Data Rate
100Mbps
No. Of Ports
1
Ethernet Type
IEEE 802.3u
Supply Current
92mA
Supply Voltage Range
3V To 3.6V
Operating Temperature Range
-40°C To +125°C
Digital Ic Case Style
LLP
No. Of
RoHS Compliant
Interface Type
MII Serial, RMII
Rohs Compliant
Yes
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
www.national.com
7.1.1 Basic Mode Control Register (BMCR)
Bit
15
14
13
12
11
10
9
8
Auto-Negotiation
Speed Selection
Restart Auto-
Duplex Mode
Power Down
Negotiation
Bit Name
Loopback
Enable
Isolate
Reset
Table 12. Basic Mode Control Register (BMCR), address 0x00
Strap, RW
0, RW/SC
0, RW/SC
Default
0, RW
0, RW
0, RW
RW
RW
Reset:
1 = Initiate software Reset / Reset in Process.
0 = Normal operation.
This bit, which is self-clearing, returns a value of one until the reset
process is complete. The configuration is re-strapped.
Loopback:
1 = Loopback enabled.
0 = Normal operation.
The loopback function enables MII transmit data to be routed to the MII
receive data path.
Setting this bit may cause the descrambler to lose synchronization and
produce a 500 s “dead time” before any valid data will appear at the
MII receive outputs.
Speed Select:
When auto-negotiation is disabled writing to this bit allows the port
speed to be selected.
1 = 100 Mb/s.
0 = 10 Mb/s.
Auto-Negotiation Enable:
Strap controls initial value at reset.
1 = Auto-Negotiation Enabled - bits 8 and 13 of this register are ig-
nored when this bit is set.
0 = Auto-Negotiation Disabled - bits 8 and 13 determine the port speed
and duplex mode.
Power Down:
1 = Power down.
0 = Normal operation.
Setting this bit powers down the PHY. Only the register block is en-
abled during a power down condition.
Isolate:
1 = Isolates the Port from the MII with the exception of the serial man-
agement.
0 = Normal operation.
Restart Auto-Negotiation:
1 = Restart Auto-Negotiation. Re-initiates the Auto-Negotiation pro-
cess. If Auto-Negotiation is disabled (bit 12 = 0), this bit is ignored. This
bit is self-clearing and will return a value of 1 until Auto-Negotiation is
initiated, whereupon it will self-clear. Operation of the Auto-Negotiation
process is not affected by the management entity clearing this bit.
0 = Normal operation.
Duplex Mode:
When auto-negotiation is disabled writing to this bit allows the port Du-
plex capability to be selected.
1 = Full Duplex operation.
0 = Half Duplex operation.
40
Description