S29AL016J70TFI020 Spansion Inc., S29AL016J70TFI020 Datasheet - Page 34

• Manufacturer Part Number: S29AL016J70TFI020
• Description: IC, FLASH, 16MBIT, 70NS, TSOP-48
• Manufacturer: Spansion Inc.

Specifications of S29AL016J70TFI020

• Memory Type: Flash
• Memory Size: 16Mbit
• Memory Configuration: 2M X 8 / 1M X 16
• Ic Interface Type: CFI, Parallel
• Access Time: 70ns
• Supply Voltage Range: 2.7 To 3.6 V
• Memory Case Style: TSOP
• Cell Type: NOR
• Density: 16Mb
• Access Time (max): 70ns
• Interface Type: Parallel
• Boot Type: Bottom
• Address Bus: 21/20Bit
• Operating Supply Voltage (typ): 3/3.3V
• Operating Temp Range: -40C to 85C
• Package Type: TSOP
• Program/erase Volt (typ): 2.7 to 3.6V
• Sync/async: Asynchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8/16Bit
• Number Of Words: 2M/1M
• Supply Current: 12mA
• Mounting: Surface Mount
• Pin Count: 48
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

34
DQ6 status bits, just as in the standard program operation. See
information.
The system may also write the autoselect command sequence when the device is in the Erase Suspend
mode. The device allows reading autoselect codes even at addresses within erasing sectors, since the codes
are not stored in the memory array. When the device exits the autoselect mode, the device reverts to the
Erase Suspend mode, and is ready for another valid operation. See
on page 30
The system must write the Erase Resume command (address bits are don’t care) to exit the erase suspend
mode and continue the sector erase operation. Further writes of the Resume command are ignored. Another
Erase Suspend command can be written after the device has resumed erasing.
Notes
1. See
2. See
Table 10.1 on page 35
DQ3: Sector Erase Timer on page 40
for more information.
for erase command sequence.
for more information.
No
Figure 10.2 Erase Operation
S29AL016J
Command Sequence
Erasure Completed
Write Erase
from System
Data = FFh?
D a t a
Data Poll
START
Yes
S h e e t
Embedded
Erase
algorithm
in progress
Write Operation Status on page 36
Autoselect Command Sequence
S29AL016J_00_10 February 18, 2010
for more