BH1710FVC-TR Rohm Semiconductor, BH1710FVC-TR Datasheet - Page 8

• Manufacturer Part Number: BH1710FVC-TR
• Description: IC AMBIENT LIGHT SENSOR WSOF6
• Manufacturer: Rohm Semiconductor
• Type: Ambient Light Sensor with Serial Outputr
• Series: -r

Specifications of BH1710FVC-TR

• Wavelength: 560nm
• Output Type: I²C™
• Package / Case: 6-WSOF Exposed Pad
• Product: Ambient Light Sensor
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

●Application circuit example of DVI terminal
© 2010 ROHM Co., Ltd. All rights reserved.
BH1710FVC
www.rohm.com
The DVI terminal is an asynchronous reset terminal. Please note that there is a possibility that IC doesn't operate normally if
the reset section is not installed after the start-up of VCC.
(Please refer to the paragraph of "Timing chart for VCC and DVI power supply sequence")
The description concerning SDA and the terminal SCL is omitted in this application circuit example. Please design the
application the standard of the I
ADDR is omitted. Please refer to the paragraph of "Timing chart for VCC and DVI power supply sequence" about the
terminal ADDR design.
ex 1) The control signal line such as CPU is connected.
ex 2) Reset IC is used.
ex 3) A different power supply is used.
※ Power supply of DVI must stand up later than power supply of VCC stand up, because it is necessary to secure reset section (1µs or more).
1, For Reset IC of the Push-Pull type
2, For Reset IC of the Open drain output
0.1µF
0.1µF
0.1µF
0.1μF
V1
2
C bus as it finishes being satisfactory. Moreover, the description concerning the terminal
VCC
ADDR
GND
VCC
ADDR
GND
VCC
ADDR
GND
VCC
ADDR
GND
BH1710FVC
BH1710FVC
BH1710FVC
BH1710FVC
SDA
SDA
SCL
SCL
DVI
DVI
SDA
SDA
SCL
SCL
DVI
DVI
8/16
V2
1kOhm
0.1µF
0.1µF
0.1µF
0.1µF
RESET
RESET
Reset IC( Pµsh-Pull type )
Reset IC( Open drain type )
Micro
Controller
Technical Note
2010.06 - Rev.B