QS30ELVC BANNER ENGINEERING, QS30ELVC Datasheet - Page 4

• Manufacturer Part Number: QS30ELVC
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING

Specifications of QS30ELVC

• Output Current: 150mA
• Sensor Output: NPN/PNP
• Supply Voltage Range Dc: 10V To 30V
• Sensor Housing: Rectangular
• Sensing Range Min: 100mm
• Sensor Input: Optical
• Body Material: ABS Plastic
• Supply Voltage Max: 30VDC

WORLD-BEAM
4
• U seful for clear object detection and other applications with small variations in contrast.
• S ets a switchpoint at 8 (clear), 16 (medium) or 32 (dark) percent below the signal from the
• S witchpoint position is selectable using the “+” and “-” buttons. Select 8, 16, or 32
• S ensor must be aimed at the reflector during the SET process. All conditions darker than
retroreflector.
the switchpoint condition result in ON output (Dark Operate). Output ON and OFF conditions
can be reversed by changing Light/Dark Operate in SETUP mode (factory setting: Dark
Operate).
percent (Switchpoint Selection).
P/N 139760 rev. A
• Align sensor to reflector
• Press and hold “+”
> 2 seconds
Push Buttons
®
Single-Point Light SET
or
QS30ELVC Series
• Align sensor to reflector
• Single-pulse remote line
0.04 seconds ≤ T ≤ 0.8 seconds
Remote
T
T
Green Power LED: OFF
Amber Output LED: ON
Bargraph: Top two signal LEDs
Switchpoint Accepted
Green Power LED: ON
Amber Output LED: ON (LO) or OFF (DO)
Bargraph: Appropriate LED ON
• S ensor returns to RUN mode with
Switchpoint Unacceptable
Green Power LED: ON
Amber Output LED: Flashing (Alarm State*)
Bargraph: All OFF
* See page 6
new settings
T
T
T
T
T
T
alternate flashing
T
T
T
Banner Engineering Corp. • Minneapolis, MN U.S.A
T
www.bannerengineering.com • Tel: [phone]
T
Figure 3. Low-contrast SET (Dark Operate
Darkest
(no signal)
T
Output ON
T
Indicators
shown)
Location of switchpoint
Switchpoint
(+) (-)
Sensor
T
selected configuration
T
Offset based on
T
Output OFF
T
T
Retro Target
Signal from
Learned
Most Light
(saturated
signal)