QS30ELVC BANNER ENGINEERING, QS30ELVC Datasheet - Page 7

• Manufacturer Part Number: QS30ELVC
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING

Specifications of QS30ELVC

• Output Current: 150mA
• Sensor Output: NPN/PNP
• Supply Voltage Range Dc: 10V To 30V
• Sensor Housing: Rectangular
• Sensing Range Min: 100mm
• Sensor Input: Optical
• Body Material: ABS Plastic
• Supply Voltage Max: 30VDC

General Notes
• Connect the gray wire of the sensor to ground (0V dc), with a remote programming switch connected between them
• Run Mode is the sensor’s normal operating condition
• The duration of each Pulse is defined as “T”: 0.04 < T < 0.8 s
• A Hold will exit TEACH MODE and return to Run Mode with previously saved changes. The duration of a Hold is: T > 2 s
• A Timeout will occur if a condition is not registered within 60 seconds, causing the sensor to return to Run Mode (during sensor configuration only)
• Sensor configuration user feedback shown on Green LED. See flow chart below.
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: [phone]
Run Mode
All other LEDs in normal
3x
4x
operating condition
8x
1x
2x
Power LED ON,
Basic Configuration Menu
Push button enable /disable
Configuration Menu
Restore factory defaults
Advanced Sensor
(legacy method )
Light SET
Remote Line TEACH
Auto LED Flashing
T
Red Signal LED Flashing
LO and current threshold LEDs Flashing
T
Power LED OFF
2x for disabled, Repeat twice
1x for enabled , Repeat twice
Power LED OFF,
All LEDs off for 1 s
WORLD-BEAM
Flash Power:
Power LED OFF
1x
2x
3x
4x
2 s Hold
1x
4x
5x
2 s Hold
2x
3x
T
T
T
T
T
T
T
T
T
T
enabled (default )
enabled (default )
T
Auto. comp.
Auto. comp.
Push button
Push button
16% (default )
disabled
disabled
T
DO (default )
T
32%
LO
8%
60 second Timeout
60 second Timeout
Exit
®
T
Flash Power 2x,
Flash Power 1x,
QS30ELVC Series
Auto LED OFF
Auto LED ON
T
Repeat twice
Repeat twice
Medium Bottle
LO LED OFF
LO LED ON
Clear Bottle
Dark Bottle
T
T
T
P/N 139760 rev. A
7