83696 SENSONOR TECHNOLOGIES AS, 83696 Datasheet
83696
Specifications of 83696
Related parts for 83696
83696 Summary of contents
Page 1
DATASHEET SP100 Pressure Sensor Series The SP100 pressure sensors are calibrated and digitally compensated silicon piezoresistive sensors with SPI interface. SP100-15 is part of this series, and in addition to pressure it provides temperature and supply voltage measurements. Each sensor ...
Page 2
... Sensonor Technologies makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Sensonor Technologies assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages ...
Page 3
Table of Contents 1 Product Description ............................................................................................................................................... - 4 - 1.1 Features .................................................................................................................................................... - 4 - 1.2 Overview .................................................................................................................................................... - Measurement Performance ................................................................................................................................... - 5 - 2.1 Pressure Measurement Performance ....................................................................................................... - 5 - 2.2 Temperature Measurement ...
Page 4
Product Description 1.1 Features 1500kPa absolute pressure sensor o Fully digitized and compensated over pressure and temperature o -40 to 125degC temperature operating range o SPI interface o Sensor self diagnosis o Unique electronic sensor IDs ...
Page 5
Measurement Performance The ADC of the sensor is an integrating charge balancing converter. Monotonic operation and no missing codes are guaranteed over the full operating range. All the following specification limits are to be understood as typical values unless ...
Page 6
Supply Voltage Measurement Performance Parameter Input range 1) Resolution Accuracy Delay between measurement command and sampling Delay between sampling and A/D conversion Supply voltage measurement total time Note: 1) The sampling operates down to 1.8 V. The specification applies ...
Page 7
Wake-Up and Reset Outputs The product provides two outputs, which may be used to interrupt or reset a microcontroller. Each output provides a pulse at regular intervals. The “wake-up and reset” are active low outputs. The Wake Up period ...
Page 8
Table 6.1 SPI timing diagram Control bytes and response bytes are 8 bits, the content of which depends upon the command given. When a control byte is shifted in, the response byte that is shifted out during the same transition ...
Page 9
SPI Timing Parameters SPI (Load capacitor at SDO = 300pF) fSCLK Max. allowed application frequency (50% duty cycle) tSDO_trans SDO transition speed, 20% to 80% (with 60pF load capacitor) tclh tcll tpcld Propagation delay (SCLK to data edge at ...
Page 10
Digital Output Characteristics These characteristics are valid for VDD 2.7V to 3.6V, temperature -40 to 125°C , and load current less than 1mA. Table 7.1 Digital output characteristics Description Output logic low Output logic high 8 Power-On Reset To ...
Page 11
Error Handling and Recovery 10.1 PROM Data The PROM contains calibration data and the identification code (ID read at power-on reset, when its contents are copied to the shadow register. The PROM contains one parity bit. If ...
Page 12
Mechanical Specifications 11.1 Physical Dimensions SP100-15 is housed pin SOIC package, easily handled by automatic production lines. Figure 11.1 Physical dimensions drawing Notes: 1) Dimension does not include mold flash, protrusions or gate burrs. Mold flash, ...
Page 13
Pin Configuration Figure 11.2 Pin configuration, top view 11.3 Marking Figure 11.3 Marking of the SP100 pressure sensor series The variables in Figure 11.3 have the following meaning: YYWWXXX : Lot ...