83696 SENSONOR TECHNOLOGIES AS, 83696 Datasheet - Page 9

• Manufacturer Part Number: 83696
• Description: SENSOR, PRESSURE, COMP, SP100-15
• Manufacturer: SENSONOR TECHNOLOGIES AS

Specifications of 83696

• Operating Temperature Range: -40°C To +125°C
• Pressure Type: Absolute
• Ic Generic Number: SP100-15
• No. Of Pins: 14
• Operating Pressure Range: 0 To 1500kPa
• Sensor Case Style: SOIC
• Supply Voltage: RoHS Compliant
• Rohs Compliant: Yes

6.3
6.4
6.5
6.6
6.7
TS1482 rev. 2
Note:
Bit 0: Overflow/underflow
Bit 1: Parity error in PROM data
Bit 2: Checksum error in shadow register
Bit 3: PROM reload / Internal Reset
Bit 4: Unspecified measurement accuracy due to low supply voltage
Bit 5: Not in use
Bit 6: Not in use
Bit 7: Measurement in progress:
The value in the temperature byte is (T+50), where T is temperature in °C. The allowed range (for which the
accuracy is specified) for this byte is 10-175, corresponding to temperatures from -40 to 125°C. Remark: the
temperature byte may show values outside this range, which have an undefined accuracy.
The pressure (in kPa) is obtained by multiplying the value in the pressure byte by the given resolution in kPa/lsb
(see section 2.1).
The supply voltage (in V) is obtained by multiplying the value in the supply byte by 0.0184, and adding 1.73.
tSDO_trans
1)
tonNCS
tpchdz
fSCLK
tfNCS
tsclch
thclch
tcsdv
thclcl
tsclcl
tpcld
thcld
tscld
SPI Timing Parameters
Digital filter for driver control register latch function. Output latch function is only enabled if positive NCS occurs after 8 CLK cycles (or a
Status Byte
Temperature Byte
Pressure Byte
Supply Voltage Byte
multiple of 8) since last negative NCS edge
tclh
tcll
0 = Measurement completed, data can be read
1 = Measurement in progress, data not available
SCLK low before NCS low (setup time SCLK to NCS edge H/L)
SDO transition speed, 20% to 80% (with 60pF load capacitor)
SDI input setup time (SCLK edge H/L after SDI data valid)
NCS filter time (Pulses shorter than tfNCS will be ignored)
SDI input hold time (SDI data hold after SCLK edge H/L)
SPI (Load capacitor at SDO = 300pF)
Propagation delay (SCLK to data edge at SDO valid)
Max. allowed application frequency (50% duty cycle)
NCS edge L/H to SDO at high impedance
NCS = LOW to data edge at SDO active
Capacitance at SDI, SDO, SCLK, NCS
SCLK edge L/H after NCS edge H/L
Minimum time SCLK = HIGH
Minimum time SCLK = LOW
SCLK low before NCS high
SCLK high after NCS high
NCS min. high time
NCS pulse filter
- 9 -
1)
Min
100
100
100
100
150
150
20
60
10
5
Max
500
100
100
100
100
25
20
10
Unit
kHz
pF
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
s
ns