44828-1162 Molex Inc, 44828-1162 Datasheet - Page 11

• Manufacturer Part Number: 44828-1162
• Description: CONN RCPT 16POS .8MM RT/ANG SMD
• Manufacturer: Molex Inc
• Series: HandyLink™ 44828r

Specifications of 44828-1162

• Connector Style: Receptacle
• Connector Type: Handylink
• Number Of Positions: 16
• Mounting Type: Surface Mount, Right Angle
• Termination: Solder
• Contact Finish: Gold
• Color: Black
• Housing Material: Thermoplastic, High Temperature
• Insulation Resistance: 1000 M Ohms
• Mounting Angle: Right
• Operating Temperature Range: - 40 C to + 85 C
• Number Of Positions / Contacts: 16
• Pitch: 0.8 mm
• Contact Plating: Gold
• Contact Material: High Performance Alloy (HPA)
• Gender: Female
• Current Rating: 1.5 A
• Mounting Style: SMD/SMT
• Termination Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Contact Finish Thickness: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 044828-1162; 044828-1162-C; 0448281162; 0448281162-C; 44828-1162-C; 448281162; 448281162-C; WM17127TR

REVISION:
DOCUMENT NUMBER:
A
6.3
6.3.1
AS-44828-001
This section provides an outline of the recommended plug cable over-molding practices
for the 45339 and 45593 plug connector modules. The 45339 connector (a 16-circuit wire
termination version) is shown, below, prior to soldering. Please note the following features:
Latch soldertails (2 places)
Figure 5. Soldertail side of the plug connector
Pre-tinned wires should be terminated to the appropriate solder tails working in sequence
and one row at a time, taking care that the insulation does not become exposed more than
1mm from the end of the terminals. The completed assembly after soldering of the wires is
shown below. Dressing of the wires should be avoided until after the soldering and
encapsulation processes are complete.
ECR/ECN INFORMATION:
EC No:
DATE:
Plug Cable Over-Molding
Wire Soldering
6/24/04
UCP2004-2588
APPLICATION SPECIFICATION
PRELIMINARY HANDYLINK™
TITLE:
CREATED / REVISED BY:
T. Gregori/ M. Simmel
Cavities under the latches (2 places)
HANDYLINK™I/O CONNECTOR SYSTEM
APPLICATION SPECIFICATION
Wire soldertails (2 rows)
Marc Simmel
CHECKED BY:
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC
Figure 6.
Plug Soldering Set-Up
NOTE: The wire bundle
must be properly supported
or clamped as shown,
during soldering and
handling, to avoid
dislodging terminals or
latches from the housing
prior to encapsulation,
application of a strain relief,
and the final over-mold.
APPROVED BY:
Joe Comerci
SHEET No.
11
of
21