72-6851 TENMA, 72-6851 Datasheet - Page 20

• Manufacturer Part Number: 72-6851
• Description: POWER SUPPLY, BENCH, 35V
• Manufacturer: TENMA

Specifications of 72-6851

• Power Supply Output Type: Variable
• No. Of Outputs: 1
• Output Voltage: 35V
• Output Current: 10A
• Load Regulation: 0.01%
• Length: 350.52mm
• Width: 210.82mm
• Height: 132.08mm
• Output Type: Variable
• Calibrated: No
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: na

Tenma 72-6851 & 72-6853 Instruction manual
Power on Settings
Most instrument settings are stored in non-volatile ram and will remain unchanged while power is
off. The following instrument status values are set at power on:
*
The standby state will be set and the instrument will be in local with the keyboard active. A
complete self-test will be performed just after power up and this will determine the values in the
Failed Output Register and the state of the FLT bit in the Status Byte Register.
Due to the non-volatile storage the power on settings are essentially modified by any command,
local or remote, which changes any value not listed above. If a defined state is require at start up
by the controller the *RST command should be issued which will load the settings as listed in the
description of that command.
If for any reason an error is detected at power up in the non-volatile ram a warning will be issued
and all settings will be returned to their default states as for a *RST command.
*
*
*
*
Registers marked thus are specific to the GPIB section of the instrument and are of limited
use in an ARC environment.
Status Byte Register
Service Request Enable Register
Standard Event Status Register
Standard Event Status Enable Register
Limit Event Status Register
Limit Event Status Enable Register
Execution Error Register
Query Error Register
Parallel Poll Enable Register
www.tenma.com
= 0
= 0
= 128 (pon bit set)
= 0
= 0 (Then set to show new limit status)
= 0
= 0
= 0
= 0
19