50664 EMIT, 50664 Datasheet - Page 2

• Manufacturer Part Number: 50664
• Description: Air Ionizer
• Manufacturer: EMIT

Specifications of 50664

• Ionizer Type: Overhead
• Flow Rate Max: 100CFM
• Depth: 3.5"
• Width: 6.5"
• Height: 42"
• Supply Voltage Vac: 115V
• Peak Reflow Compatible (260 C): No
• Flow Rate: 100CFM
• External Width: 6.50"
• Supply Voltage: 110V
• External Depth: 3.50"
• External Height: 42.00"
• Leaded Process Compatible: No
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

ionization with ease of adjustability, communication capability, and the flexibility of a micro-
controller based design to produce a versatile and stable ionization system. Three fans
produce extended ionization coverage, and are ideal for areas where bench space is limited.
(Note: for the 2 fan unit, disregard any instructions relating to the 3 fan unit or fan 3.
Optional network software and remote control (ZVI-IR) for adjustments are available.
Installation
Remove the ionizer from the carton and inspect for shipping damage. Included with the unit
are:
1. 50664/50665 or 50671/50672 Overhead Ionizer
2. AC Power Cord
3. Keys (to power on)
4. Hanging Kit
220v). It can be verified or reset by referring to the Maintenance / Cleaning section of these
instructions.
The unit must have a good earth ground to maintain proper balance. Install the unit in the
desired location, making sure that the airflow will not be restricted through the unit. Make sure
the ON/OFF key switch, located on the side of the unit, is in the “OFF” position. Plug the
power cord into the unit and then into the appropriate AC power source. This equipment has a
grounding type plug that has a third (grounding) pin. This plug will only fit into a grounding
type power outlet. If the plug does not fit into the outlet, contact qualified personnel to install
the proper outlet. Do not alter the plug in any way.
Setup and Operation
is located on the left end of the unit along with the RS485 input/output ports for the optional
ZVI software package. The control buttons along with the LED display are located on the front
of the unit. The control buttons are numbered left to right as shown in Figure 1. Button #1 ( )
TB-6534 Page 2 of 8
The Overhead Zero Volt Ionizer combines the effectiveness of steady-state DC
The AC input voltage should be set to the user’s specification prior to shipping (120v or
Before installing unit verify that the AC outlet is properly connected to earth ground.
The unit is powered on and off by using the keys supplied with the unit. The key switch
Installation, Operation, and Adjustment Instructions
50664/50665 & 50671/50672
OVERHEAD ZERO VOLT IONIZER
Revision July 2008
© 2008 DESCO INDUSTRIES INC.
Employee Owned