EVK-SH3000USB Semtech, EVK-SH3000USB Datasheet - Page 11

• Manufacturer Part Number: EVK-SH3000USB
• Description: Tools, Development Kit
• Manufacturer: Semtech

Specifications of EVK-SH3000USB

• Kit Contents: Evaluation Kit
• Tool / Board Applications: MicroBuddy Devices
• Development Tool Type: Hardware / Software - Eval/Demo Board
• Mcu Supported Families: SH3000
• For Use With: SH3000 MicroBuddy
• Lead Free Status / RoHS Status: na

SH3000 Evaluation Kit User Guide v0.96
SYSTEM MANAGEMENT
G. This is the 4-bit internal reference resistor trim. It allows the user to calibrate the RC oscillator to exactly
H. Oscillator adjustment – This adjustment is the 6 bit internal oscillator adjust value. See SH3000 Reference
I.
J. Apply – This button updates the register table only with the settings set in this window. By pressing the
K. This switch enables the internal 32.768 kHz reference signal to be output to an external pin on the MicroBuddy
32.768 kHz based on the internal reference resistor. This is a default value set at the factory and should not be
changed, unless the user wants to re-calibrate the RC oscillator because of some difference in operating
conditions from the factory conditions.
Manual for more information.
Change Now – This button updates the register table with the settings set in this window, and updates the
MicroBuddy immediately with these values.
Registers tab, the user can see which registers are affected by this block.
(J). This signal can be used for other low-power devices, but takes power from the system as the clock runs even
when power has been removed by using V
details.
2003-03
BAK
as a power source. See the SH3000 Reference Manual for more
11
EVK-SH3000USB MicroBuddy™
Copyright ©2002-2003 Semtech Corporation
Evaluation Kit User Guide
www.semtech.co
Preliminary
m