HFCT-5006 Avago Technologies US Inc., HFCT-5006 Datasheet - Page 4

• Manufacturer Part Number: HFCT-5006
• Description: Fiber Optics, Evaluation Kit
• Manufacturer: Avago Technologies US Inc.

Specifications of HFCT-5006

• Silicon Core Number: HFCT-5954xxxZ, AFCT-5961xxxZ, AFCT-5964xxxZ
• Kit Contents: OC-3/OC-12 LC Evaluation Board, Associated Technical Literature
• Main Purpose: Interface, Fiber Optics
• Embedded: No
• Utilized Ic / Part: HFCT-595x, AFCT-596x
• Primary Attributes: SFF LC Singlemode for SONET/SDH, ATM Applications
• Operating Voltage: 3.14 V to 3.47 V
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Secondary Attributes: -
• Lead Free Status / Rohs Status: Details

Package
The overall package concept for these devices consists
of the following basic elements; two optical subassem-
blies, a electrical subassembly and the housing as illus-
trated in the block diagram in Figure 3.
The package outline drawing and pin out are shown in
Figures 4 and 5. The details of this package outline and
pin out are compliant with the multisource definition of
the 2 x 5 DIP. The low profile of the Avago Technologies
transceiver design complies with the maximum height
allowed for the LC connector over the entire length of
the package.
The electrical subassembly consists of high volume
multilayer printed circuit board on which the IC and
various surface-mounted passive circuit elements are
attached.
NOTE: NOSE CLIP PROVIDES CONNECTION TO CHASSIS GROUND FOR BOTH EMI AND THERMAL DISSIPATION.
Figure 3. Block Diagram
DATA OUT
DATA OUT
SIGNAL
DATA IN
DATA IN
Tx DISABLE
4
DETECT
AND CONTROL
LASER DRIVER
T
X
CIRCUIT
QUANTIZER IC
GROUND
R
T
X
X
SUPPLY
SUPPLY
R
X
MONITORING
LASER DIODE
MODULATOR
LASER BIAS
GROUND
CASE
The optical subassemblies are attached to the electrical
subassembly. These two units are then fitted within the
outer housing of the transceiver. The housing is then
encased with a metal EMI protective shield.
The electrical subassemby carries the signal pins that
exit from the bottom of the transceiver. The solder
posts are designed to provide the mechanical strength
required to withstand the loads imposed on the trans-
ceiver by mating with the LC connectored fiber cables.
Although they are not connected electrically to the
transceiver, it is recommended to connect them to
chassis ground.
PIN PHOTODIODE
PREAMPLIFIER
SUBASSEMBLY
LASER
OPTICAL
SUBASSEMBLY
NOTE
LC
RECEPTACLE