2000905-1 Tyco Electronics, 2000905-1 Datasheet - Page 17

• Manufacturer Part Number: 2000905-1
• Description: BACKPLANE CONNECTOR, RECEPT, 180POS
• Manufacturer: Tyco Electronics
• Series: Fortis Zdr

Specifications of 2000905-1

• Row Pitch: 1.6mm
• Pitch Spacing: 1.9mm
• No. Of Contacts: 180
• Gender: Receptacle
• Contact Termination: Press Fit
• No. Of Rows: 9
• Contact Plating: Gold
• Connector Type: Backplane
• Product Type: Contact Modules
• Contact Gender: Socket (Female)
• Number Of Positions / Contacts: 180
• Mounting Style: PCB
• Mounting Angle: Vertical
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

3.11. Module Removal
The minimum amount of extraction force per contact is 0.028 N [.10 oz- - force].
3.12. Replacement and Repair
Damaged or defective modules MUST NOT be used. The modules can be replaced a maximum of two times.
4. QUALIFICATION
No qualifying support for the Fortis Zd pc board connector system was defined at the time of publication of this
document.
5. TOOLING
Tooling needed to seat the modules are shown in Figure 15.
5.1. Application Tooling
The application tooling (such as a manual arbor press) used to seat these modules must provide sufficient
amount of downward force to insert the contacts into the pc board holes.
5.2. PC Board Support Fixture
A pc board support fixture must be used to prevent bowing of the pc board during the placement of the
modules on the board. The support fixture must have a flat surface with holes or a channel large enough and
deep enough to receive any protruding components. The pc board must be secured to the support fixture to
prevent movement of the pc board during seating.
The pc board support fixture must also be used when removing the modules from the pc board.
5.3. Flat Rock Tooling
Commercially available bar stock (flat rock tooling) with a flat surface large enough to cover all contacts must
be used with the application tooling to seat and remove these modules.
For removing the modules from the pc board, it is suggested that the pc board be supported from the
connector side.
Rev B
Manual Arbor Press
(Typical)
PC Board Support
(Must Be Custom Made)
Figure 15
Flat Rock Tooling
(Must Be Custom Made)
114- - 13267
17 of 18