LQ084V3DG02 Sharp Microelectronics, LQ084V3DG02 Datasheet - Page 15

• Manufacturer Part Number: LQ084V3DG02
• Description: LCD Graphic Display Modules & Accessories VGA 640x480 Transm. 8.4
• Manufacturer: Sharp Microelectronics

Specifications of LQ084V3DG02

• Lcd Display Type: VGA
• Interface Type: Digital
• Viewing Area (h X W): 128.16mm X 170.88mm
• Supply Voltage: 3.3V
• External Depth: 11.6mm
• External Length / Height: 149.5mm
• External: RoHS Compliant
• Display Mode: Transmissive
• Svhc: No SVHC (15-Dec-2010)
• Rohs Compliant: Yes
• Backlight Type: LED
• Backlighting Colour: White
• Pixel Pitch (h X W): 0.267mm X 0.267mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

10
11
display
11.1 Assembling the module
11.2 Instruction for assembling
11.3
Display Qualities
Handling Instruction
Please refer to the Outgoing Inspection Standard.
1) Be sure to design the cabinet so that the module can be installed without any extra
2) Please power off the module before you connect or disconnect input connector.
3) Make sure to connect module’s metal shield case to GND of DCDC converter
1) Since the front polarizer is easily damaged, pay attention to avoid rubbing with
2) How to eliminate dust on polarizer.
3)
4)
5)
4) The LED used for this product is very sensitive to the temperature. Luminance decreases
2）The module should be protected with cover to prevent salt content and/or water droplet.
3) If a minute particle enters in the module and adheres to an optical material, it may cause
1)The notes and cautions below should be followed when product is designed with this
stress such as warp or twist.
If its connection is not made perfectly, some of the following problems may occur.
circuit.
rapidlywhen it is used for a long time under the environment of the high temperature. Please
consult our company when it is used under the environment like the above mentioned.
non-uniformity issue, etc. Therefore, fine-pitch filters have to be installed to cooling and
inhalation hole if you intend to install a fan.
something hard or sharp.
module.
Take enough shielding countermeasure not to interfere to peripheral electronic device.
When the metal section [shield case or shield back case] is soiled, wipe it off with dry and
soft cloth. If not so easy,
long term, it may cause stain or tarnish, it should be wipe off immediately.
Since TFT-LCD panel is made of glass substrate, dropping the panel or banging it against
hard objects may cause cracking or fragmentation.
Since CMOS LSIs are incorporated in this module, please pay special care to electrostatic
while handling it, and earth human body.
Caution in product design
a) Increase of noise caused by backlight
b) Unstable output from DCDC converter circuit
c) Possibly over-heat in some section
･Blow dust away by N
･Since the front polarizer is easily damaged, wiping dust off is not adequate.
of adhesive tape.
If the polarizer is soiled, it is suggested to peel dust off by using adhesive surface
breathe upon it then wipe off. If the water droplet or fat is left for
2
blower having measures of electrostatics
LD-19Z60A-13