0638190200 Molex Inc, 0638190200 Datasheet - Page 4

• Manufacturer Part Number: 0638190200
• Description: HAND CRIMP TOOL
• Manufacturer: Molex Inc

Specifications of 0638190200

• Lead Free Status / RoHS Status: RoHS Not Applicable

Hand Crimp Tool For C-Grid III™ Female Crimp Terminals
Doc No: ATS-63819-0200 Release Date: 11-02-07
Revision: A
Note:
A crimp height chart is provided with this manual as Reference Only. Due to the wide range of wires, strands,
insulation diameters, and durometers available, actual crimp height measurements may very slightly. An
occasional, destructive, pull force test should be performed to check hand tool crimp. Pull Force value Must
exceed the Minimum pull force specifications listed.
Locator Replacement
See the parts list on the last page of this
document for the proper locator order number.
Follow the steps below to replace the locator.
1. Open the crimp hand tool.
2. Squeeze gently on the lower area shown in
3. Lift and pull away from the hand tool. The
4. To reinstall the new locator, make sure the
5. Press the red insert down as far as it will go
6. Holding onto the lower part of the locator with your thumb and index finger, insert the locators top hooks (2)
7. Rotate the locator down and press the lower tabs into the two bottom slots of the hand tool. To secure the
Right or Left Hand Operation
This hand tool has an added feature that can be
converted from a right handed application to a left
handed application. It is necessary to reverse the
tooling if using the left handed application along with
the locator. Follow the steps below:
1. The locator must be removed before reversing
2. Remove the M3 BHCS which is holding the upper
3. Flip the upper tooling to the opposite side and
Figure 7A with your thumb and index finger.
The lower tabs of the locator should
disengage from the hand tool.
top locator hooks should slip out of the top
slots easily. See Figure 7A.
hand tool is in the open position.
as shown in Figure 7B.
into the hand tool top slots.
locator into place, the lower tabs must snap into
place on the hand tool frame.
the tooling.
tooling.
replace the M3 BHCS. Make sure the small
markings on the front and back of the hand tool frame, match up and are on the outside of the hand tool frame.
See Figure 8 and 9.
Revision Date: 11-02-07
SQUEEZE
HERE
UNCONTROLLED COPY
M3 BHCS
Figure 7A
TOOLING
LOWER TABS
Figure 8
TOP SLOTS OF
PULL OPEN
LOCATOR
TOP HOOKS
HANDTOOL
JAWS OPEN
PUSH ON
HANDLE
SQUEEZE
HERE
CENTER OF LOCATOR
DOWN POSITION
MAKE SURE
IS IN THE
Figure 7B
Page 4 of 7
TOOLING