LPC2478-STK-MICTOR Olimex Ltd., LPC2478-STK-MICTOR Datasheet - Page 12

• Manufacturer Part Number: LPC2478-STK-MICTOR
• Description: MCU, MPU & DSP Development Tools DEV BRD FOR LPC2478
• Manufacturer: Olimex Ltd.

Specifications of LPC2478-STK-MICTOR

• Processor To Be Evaluated: LPC2478
• Data Bus Width: 16 bit, 32 bit
• Interface Type: USB, I2C, SPI, UART
• Dimensions: 5.3 in x 4 in
• Operating Supply Voltage: 3.3 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

when you want external software to
jumper is used in combination with the
ETM_E
BDS_E
C/SC
PD/CTRL
EXT/JLINK
MCU
controller.
signal
from the
the JTAG
the JTAG
If you put this jumper, you enable external software to
control the Reset signal to the processor. This is used
Boundary scan enable.
Default state is open.
This jumper controls the USB device interface.
If 1-2 are shorted, the USB is always enabled.
If 2-3 are shorted, the USB Enable is controlled by the
Default state is 2-3 shorted.
This jumper controls the PHY signal of the Ethernet
If there is no jumper, the PHY is always enabled.
If 1-2 are shorted, the PHY is disabled
If 2-3 are shorted, the PHY is controlled by the LPC2478
Default state is no jumper (opened).
This jumper controls the JLINK +5V power line (pin19) of
If 1-2 are shorted, the JLINK +5V power line (pin19) from
If 2-3 are shorted, the board is supplied with +5VDC
Default state is 2-3 shorted.
Default state is open.
If you put this jumper, you enable the MICTOR Trace
Default state is open.
Page 12
PHY_PD.
LPC2478 signal USB1_CONNECT.
and the +5VDC power supply of the board.
interface supplies the board with +5VDC.
+5VDC voltage regulator.
connector.
program the LCP2478. This
ISP_E jumper.