LPC2478-STK-MICTOR Olimex Ltd., LPC2478-STK-MICTOR Datasheet - Page 3

• Manufacturer Part Number: LPC2478-STK-MICTOR
• Description: MCU, MPU & DSP Development Tools DEV BRD FOR LPC2478
• Manufacturer: Olimex Ltd.

Specifications of LPC2478-STK-MICTOR

• Processor To Be Evaluated: LPC2478
• Data Bus Width: 16 bit, 32 bit
• Interface Type: USB, I2C, SPI, UART
• Dimensions: 5.3 in x 4 in
• Operating Supply Voltage: 3.3 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PROCESSOR FEATURES:
Hardware: Programmer/Debugger – ARM-JTAG, ARM-USB-TINY or ARM-
Software:
LPC-2478STK board use MCU LPC2478 from NXP with these features:
ARM7TDMI-S processor, running at up to 72 MHz.
512 kB on-chip flash program memory with In-System Programming
(ISP) and In-Application Programming (IAP) capabilities. Flash
program memory is on the ARM local bus for high performance CPU
access.
98 kB on-chip SRAM includes:
LCD controller, supporting both Super-Twisted Nematic (STN) and
Thin-Film Transistors (TFT) displays.
Dual Advanced High-performance Bus (AHB) system allows
simultaneous Ethernet DMA, USB DMA, and program execution from
on-chip flash with no contention.
EMC provides support for asynchronous static memory devices such
as RAM, ROM and flash, as well as dynamic memories such as Single
Data Rate SDRAM.
Advanced Vectored Interrupt Controller (VIC), supporting up to 32
vectored interrupts.
General Purpose AHB DMA controller (GPDMA) that can be used with
and SD/MMC interface as well as for memory-to-memory transfers.
Serial Interfaces:
-
-
-
-
-
-
-
-
64 kB of SRAM on the ARM local bus for high performance CPU
access.
16 kB SRAM for Ethernet interface. Can also be used as general
purpose SRAM.
16 kB SRAM for general purpose DMA use also accessible by the
USB.
2 kB SRAM data storage powered from the RTC power domain.
Dedicated DMA controller.
Selectable display resolution (up to 1024 × 768 pixels).
Supports up to 24-bit true-color mode.
Ethernet MAC with MII/RMII interface and associated DMA
controller. These functions reside on an independent AHB.
programmer such as FlashMagic, you may need RS232 or other
cables.
USB-OCD or other compatible programming/debugging tool.
The board comes pre-loaded with Uboot and the CD contains
ucLinux image you can copy to USB flash disk and boot. You
can use GCC or other commercial ARM compiler if you want to
develop without uclinux RTOS.
Page 3