CS4351-DZZR Cirrus Logic Inc, CS4351-DZZR Datasheet - Page 19

• Manufacturer Part Number: CS4351-DZZR
• Description: IC,D/A CONVERTER,DUAL,24-BIT,TSSOP,20PIN
• Manufacturer: Cirrus Logic Inc

DS566F1
4.6.2
4.6.3
4.7
4.8
4.8.1
Mute Control
The Mute Control pins go active during power-up initialization, reset, muting (see
MCLK to LRCK ratio is incorrect. These pins are intended to be used as control for external mute circuits to
prevent the clicks and pops that can occur in any single-ended single supply system.
Use of the Mute Control function is not mandatory but recommended for designs requiring the absolute min-
imum in extraneous clicks and pops. Also, use of the Mute Control function can enable the system designer
to achieve idle channel noise/signal-to-noise ratios which are only limited by the external mute circuit.
Please see the
tems. This FET circuit must be placed in series after the RC filter, otherwise noise may occur during muting
conditions. Further ESD protection will need to be taken into consideration for the FET used. If dual supplies
are available, the BJT mute circuit from Figure 12 in the CS4398 datasheet (active Low) may be used.
Grounding and Power Supply Arrangements
As with any high resolution converter, the CS4351 requires careful attention to power supply and grounding
arrangements if its potential performance is to be realized.
rangements, with VA_H, VA, VD, and VL connected to clean supplies. If the ground planes are split between
digital ground and analog ground, the GND pins of the CS4351 should be connected to the analog ground
plane.
All signals, especially clocks, should be kept away from the VBIAS and VQ pins in order to avoid unwanted
coupling into the DAC.
Power-Down
To prevent audible transients at power-down, the device must first enter its power-down state. When this
occurs, audio output ceases and the internal output buffers are disconnected from AOUTA and AOUTB.
In their place, a soft-start current sink is substituted which allows the DC-blocking capacitors to slowly dis-
charge. Once this charge is dissipated, the power to the device may be turned off and the system is ready
for the next power-on.
Discharge Time
To prevent an audio transient at the next power-on, the DC-blocking capacitors must fully discharge be-
fore turning on the power or exiting the power-down state. If full discharge does not occur, a transient will
occur when the audio outputs are initially clamped to GND. The time that the device must remain in the
power-down state is related to the value of the DC-blocking capacitance and the output load. For example,
with a 3.3 µF capacitor, the minimum power-down time will be approximately 0.4 seconds.
Capacitor Placement
Decoupling capacitors should be placed as close to the DAC as possible, with the low value ceramic ca-
pacitor being the closest. To further minimize impedance, these capacitors should be located on the same
layer as the DAC. If desired, all supply pins may be connected to the same supply, but a decoupling ca-
pacitor should still be placed on each supply pin.
Note:
The CDB4351 evaluation board demonstrates the optimum layout and power supply arrangements.
All decoupling capacitors should be referenced to analog ground.
“Typical Connection Diagram” on page 14
for a suggested mute circuit for single supply sys-
Figure 4
shows the recommended power ar-
Section
6.4.3), or if the
CS4351
19