MTCBA-G2-EN2-GP Multi-Tech Systems, MTCBA-G2-EN2-GP Datasheet - Page 54

• Manufacturer Part Number: MTCBA-G2-EN2-GP
• Description: ROUTER WIRELESS QUAD GPRS GPS
• Manufacturer: Multi-Tech Systems
• Series: MultiModem® rCellr

Specifications of MTCBA-G2-EN2-GP

• Function: Transceiver, GPRS, Router
• Modulation Or Protocol: GSM, GPRS
• Frequency: 850MHz, 900MHz, 1.8GHz, 1.9GHz, 1575.42MHz
• Applications: General Purpose
• Interface: RJ-45, RS-232
• Sensitivity: -161dB
• Voltage - Supply: 9 V ~ 32 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 881-1087

Chapter 4 – Using the Web Management Software
54
S ave Button
1 0 4 B 1 1 4 B
Click the Save button to save these settings.
Left Next Hop
Local WAN IP
Local LAN
Remote Gateway IP
FQDN
Remote LAN
NetBIOS Broadcast
through 0xfff is recommended). If you have more than one manual connection, then the
SPI Base must be different for each one.
Next Hop is the address of the next device in a routing table’s path that moves a packet
to it’s destination. This setting can be configured or left as a static value: 0.0.0.0. When
not configured, the value is set to the Gateway of the Box/Gateway configured on the
Interface/Right IP. The selection is based on the Left and Right IP.
Select the Interface to initiate the IPSec tunnel (Left Security Gateway).
Select the internal subnet of the local security gateway for which the security services
are to be provided. If the router acts as a host, this should be configured as None. Other
Select the interface in which the IPSec tunnel ends. In the case of Road Warriors with a
Dynamic IP addresses, this should be configured as ANY. Other options include: LAN,
LAN Interface, WAN 1, WAN 1 Interface, and None.
FQDN is a Fully Qualified Domain Name that resolves to the Local Wan IP of the router
or in the case of GRE/IPSEC, it is used to identify the Wan IP of the remote location.
This is provided by your ISP or created by you if you are using a Dynamic DNS service.
When FQDN is selected, the Remote Gateway IP should be left blank.
This is the internal subnet of the remote security gateway for which the security services
are to be provided. If the remote end is a host, this should be configured as None.
Check this option to enable broadcasts over the connection. It will allow computers on
the network to share Microsoft file and printer sharing information.
options are: Any, LAN, LAN Interface, WAN 1, WAN 1 Interface.
Multi-Tech Systems, Inc. MultiModem rCell User Guide