8808A 120V Fluke Electronics, 8808A 120V Datasheet - Page 66
![DMM 5.5 RES RS-232 INTERFACE](/photos/27/4/270432/8808a-120v_sml.jpg)
8808A 120V
Manufacturer Part Number
8808A 120V
Description
DMM 5.5 RES RS-232 INTERFACE
Manufacturer
Fluke Electronics
Type
Digital (DMM)r
Specifications of 8808A 120V
Includes
Test Leads
Style
Bench
Display Digits
5.5
Display Type
VFD, Dual
Display Count
200000
Function
Voltage, Current, Resistance, Frequency
Functions, Extra
Continuity, dB, Diode Test
Features
Hold, Min/Max, RS-232 Port
Ranging
Auto/Manual
Response
True RMS
Lead Free Status / RoHS Status
Not applicable / RoHS non-compliant
Other names
614-1068
8808A
Users Manual
4-6
Character Echoing and Deletion
Device Clear Using ^C (CNTRL C)
RS-232 Prompts
Getting Started with an Installation Test
Installation Test for RS-232 Operation
When the Meter is operated via the RS-232 interface, you can control whether characters
are echoed to the host's display screen.
When Echo is on, characters sent to the Meter are echoed on the host's display screen and
prompts are returned. When Echo is off, characters are not echoed, and prompts are not
returned. To set the Echo parameter, refer to the “Setting Communication Parameters
(RS-232)” section earlier in this chapter.
If you send a character to the Meter over the RS-232 interface directly from a keyboard,
pressing the <BACKSPACE> key deletes the previous character. A backspace is echoed
to the display screen if Echo is on.
^C (CNTRL C) causes “=>” followed by a carriage return and line feed to be output.
When the host sends a command to the Meter over the RS-232 interface, the Meter parses
the command, executes it, returns a response (if appropriate), and then sends one of the
following prompts:
=>
?>
!>
After the Meter is cabled to a host per “Cabling the Meter to a Host or Printer (RS-232)”
and is prepared to communicate with the host via the RS-232 interface, test the system as
follows to verify that it is operational.
This procedure confirms that the Meter is properly set up and cabled for remote
operations:
1. Press P to turn the Meter on.
2. Verify that the computer interface parameters (baud, parity, etc.) are set
3. Turn the host on.
4. Type *IDN? and press Enter.
5. Verify that the Meter sends the following response:
No errors detected. Command was successfully parsed and executed. The
interface is ready for another command.
Command error detected. Command was not executed because it was not
understood. For example, the Meter received an input string that contained a
syntax error.
Execution error or device-dependent error detected. Command was understood,
but not executed. For example, user attempted to use FREQ to perform a VDC
measurement.
correctly.
FLUKE, 8808A, nnnnnnn, n.n Dn.n
Where nnnnnnn is the Meter’s serial number; n.n is the main software
version; and Dn.n is the display’s software version.