R0K5562T0S000BE Renesas Electronics America, R0K5562T0S000BE Datasheet - Page 18

• Manufacturer Part Number: R0K5562T0S000BE
• Description: KIT STARTER FOR RX62T
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K5562T0S000BE

• Design Resources: RX62T CPU Board Schematics
• Contents: Board, Cable, CD, Documentation, Emulator, Power Supply
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: RX600 series

RSKRX62T
6. Configuration
6.1
This section lists the option links that are used to modify the way RSK operates in order to access different
configurations. Configurations are made by modifying link resistors or headers with movable jumpers.
A link resistor is a 0Ω surface mount resistor, which is used to short or isolate parts of a circuit. Option links are
listed in the following sections, detailing their function when fitted or removed. Bold, blue text indicates the default
configuration that the RSK is supplied with. Refer to the component placement diagram (§3) to locate the option
links and jumpers.
6.2
Table 6-1 below details the option links associated with configuring the MCU operating modes and emulator
support.
*By default, this jumper is not fitted to the RSK. R66 is fitted by default and MD0 is pulled high by R64.
Table 6-2 below details the different configurations and functions of the MCU operating mode jumpers.
REJ10J2194-0100
Oct 10, 2010
When removing soldered components, always ensure that the RSK is not exposed to a soldering iron for intervals
greater than 5 seconds. This is to avoid damage to nearby components mounted on the RSK.
When modifying a link resistor, always check the related option links to ensure there is no possible signal contention or
short circuits. Because many of the MCU’s pins are multiplexed, some of the peripherals must be used exclusively.
Refer to the RX62T hardware manual and RSKRX62T board schematics for further information.
J6*
J8
J7
Reference
Reference
Modifying the RSK
MCU Configuration
Pins 1 and 2 shorted.
Do not use this setting.
Rev. 1.00
Pins 1 and 2 shorted.
Connects
Board_VCC.
Emulator enabled.
Pins 1 and 2 shorted. Connects MDE to
Board_VCC (pulled to GROUND by
R67).
Big Endian selected.
Position One
Position One
EMLE
Table 6-2: MCU Operating Mode Jumpers
to
Table 6-1: MCU Option Links
Pin 2 and 3 shorted.
Single Chip Mode & Boot
Mode.
Pins
Connects
GROUND.
Unused.
Position Two
2
and
Pins 1 and 2 open. Connects MDE to
GROUND (pulled by R67).
Little Endian selected.
EMLE
3
open.
to
Position Two
All pins open.
Single Chip Mode Only
All pins open.
Do
setting.
Position Three
not
use
this
6. Configuration
R67
Related Ref.
R66
R68
Related Ref.
Page 18 of 40