M41T0DW6E STMicroelectronics, M41T0DW6E Datasheet - Page 8
![Real Time Clock Serial 64 (8x8)](/photos/16/11/161122/soic-8_sml.jpg)
M41T0DW6E
Manufacturer Part Number
M41T0DW6E
Description
Real Time Clock Serial 64 (8x8)
Manufacturer
STMicroelectronics
Datasheet
1.M41T0DW6F.pdf
(22 pages)
Specifications of M41T0DW6E
Maximum Operating Temperature
+ 85 C
Minimum Operating Temperature
- 40 C
Mounting Style
SMD/SMT
Package / Case
TSSOP-8
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
2.1.4
2.1.5
8/22
Data valid
The state of the data line represents valid data when after a start condition, the data line is
stable for the duration of the High period of the clock signal. The data on the line may be
changed during the Low period of the clock signal. There is one clock pulse per bit of data.
Each data transfer is initiated with a start condition and terminated with a stop condition.
The number of data bytes transferred between the start and stop conditions is not limited.
The information is transmitted byte-wide and each receiver acknowledges with a ninth bit.
By definition, a device that gives out a message is called “transmitter”, the receiving device
that gets the message is called “receiver”. The device that controls the message is called
“master”. The devices that are controlled by the master are called “slaves”.
Acknowledge
Each byte of eight bits is followed by one acknowledge bit. this acknowledge bit is a low level
put on the bus by the receiver, whereas the master generates an extra acknowledge related
clock pulse.
A slave receiver which is addressed is obliged to generate an acknowledge after the
reception of each byte. Also, a master receiver must generate an acknowledge after the
reception of each byte that has been clocked out of the slave transmitter.
The device that acknowledges has to pull down the SDA line during the acknowledge clock
pulse in such a way that the SDA line is a stable Low during the High period of the
acknowledge related clock pulse. Of course, setup and hold times must be taken into
account. A master receiver must signal an end-of-data to the slave transmitter by not
generating an acknowledge on the last byte that has been clocked out of the slave. In this
case, the transmitter must leave the data line high to enable the master to generate the
STOP condition.
Figure 4.
CLOCK
DATA
CONDITION
Serial bus data transfer sequence
START
DATA VALID
DATA LINE
STABLE
DATA ALLOWED
CHANGE OF
CONDITION
STOP
AI00587