9015 JEWELL / MODUTEC, 9015 Datasheet - Page 17

• Manufacturer Part Number: 9015
• Description: MULTIMETER DIGITAL HANDHELD, 3-1/2 DIGIT
• Manufacturer: JEWELL / MODUTEC

Specifications of 9015

• Dmm Type: Handheld
• Voltage Measuring Range Dc: 1000
• Voltage Measuring Range Ac: 750
• Current Measuring Range Dc: 2mA To 10A
• Current Measuring Range Ac: 20mA To 10A
• Lead Free Status / RoHS Status: na

7.5.4 If the display indicates overrange, i.e. “1- - -”, disconnect the test probes
7.5.5 If the displayed value is less than “200” (decimal point not shown), a more
7.6 AC Current Measurement:
7.6.1 Connect the black test lead to the COM jack. Connect the red test lead to
7.6.2 If the red test lead is inserted into the 10A jack, set the RANGE switch to
7.6.3 If the red test lead is inserted into the mA jack, set the RANGE switch
If the magnitude of the current to be measured is unknown, always start
by setting the meter to the highest range, and then to lower ranges,
Do not rotate the RANGE switch with the input applied to the meter.
If the input current is higher than 10A, do not attempt to measure!
accurate reading may be obtained by setting the RANGE switch to a lower
If the current is less than 200mA, connect the red test lead to the mA jack.
switch to the next lower position. Reconnect the test probes to the circuit
from the circuit and reconnect the red test lead to the 10A jack. Set the
RANGE switch to the 10A
the circuit. Read the value from the LCD. If the input current exceeds the
measurement capability of the meter, as evidenced by a display of over
10 amps, or an overrange display, it should not be measured.
range. Disconnect the probes from the circuit and rotate the RANGE
and observe the reading on the LCD display. If the RANGE switch is
already on the lowest position (i.e. 2mA), no greater measurement
resolution can be obtained.
to the 200mA
the 10A jack unless it is known that the input current is less than 200mA.
the 10A
Use caution when measuring current in a circuit with voltages
above 30 VAC. Do not use meter to measure current in
~
circuits whose voltage exceeds 250V AC/DC.
position. Read the value of the current on the LCD display.
until a satisfactory reading is obtained.
~
position. Read the value of the current on the LCD.
WARNING!!!
position, and reconnect the test leads to
16