9015 JEWELL / MODUTEC, 9015 Datasheet - Page 4

• Manufacturer Part Number: 9015
• Description: MULTIMETER DIGITAL HANDHELD, 3-1/2 DIGIT
• Manufacturer: JEWELL / MODUTEC

Specifications of 9015

• Dmm Type: Handheld
• Voltage Measuring Range Dc: 1000
• Voltage Measuring Range Ac: 750
• Current Measuring Range Dc: 2mA To 10A
• Current Measuring Range Ac: 20mA To 10A
• Lead Free Status / RoHS Status: na

2.14 Do not exceed the maximum voltage or current limitations of the meter
2.15 Do not apply voltage or current to the input of the meter when it is set to any
2.16 Do not apply voltage or current to the input of the meter when it is set to the
2.17 Do not attempt to measure a voltage source with the test leads plugged into
2.18 Do not rotate the Function switch with the test leads connected to the
2.19 Replace fuses only with exact or equivalent fuses. Do not “bridge” fuses out
2.20 Do not apply voltages to the input of the meter which are elevated above the
2.21 Do not continue to use meter when the “low battery” symbol
2.22 Use caution when working with voltages above 25 volts AC or 35 volts DC.
2.23 This meter is not for use by children. Failure to observe this precaution may
2.24 Do not use this meter to make measurements in adverse environments such
2.25 Do not use meter in condensing atmospheres. That is, do not use meter in
conditions where ambient temperature and humidity could cause condensa-
(see product specifications). Doing so may damage the meter and/or
injure the user.
of the Ohms Ω ranges. Doing so may damage the meter and/or injure
the user.
Diode Test
the meter and/or injure the user.
the meter’s mA or 10A jacks. Doing so may damage the meter and/or
injure the user.
circuitry to be tested. Doing so may damage the meter or the circuitry,
and/or injure the user.
of circuit. Failure to observe this precaution may result in damage to the
meter or injury to the user.
earth ground potential by more than 600V AC/DC. Doing so may damage
the meter and/or injure the user.
displayed. The displayed reading may be in error and lead the user to
believe that no hazard exists, when in fact, dangerous voltages or currents
may be present. Failure to observe this precaution may result in damage to
the meter or injury to the user.
Such voltages may cause a life threatening electrical shock.
result in damage to the meter or injury to the user.
as rain, snow, fog, or locations with steam, explosive gases or dusts.
Doing so may damage the meter and/or injure the user.
tion of water inside of meter. Doing so may cause injury to the user.
or Continuity Beeper
3
modes. Doing so may damage
_
+
is