N25Q128A13B1240E NUMONYX, N25Q128A13B1240E Datasheet - Page 17
![no-image](/images/manufacturer_photos/0/4/484/numonyx_sml.jpg)
N25Q128A13B1240E
Manufacturer Part Number
N25Q128A13B1240E
Description
SERIAL NOR, 128MB
Manufacturer
NUMONYX
Datasheet
1.N25Q128A13BSF40G.pdf
(180 pages)
- Current page: 17 of 180
- Download datasheet (6Mb)
N25Q128 - 3 V
Signal descriptions
2.5
Hold (HOLD) or Reset (Reset)
The Hold (HOLD) signal is used to pause any serial communications with the device without
deselecting the device.
Reset functionality is present instead of Hold in devices with a dedicated part number. See
Section 16: Ordering
information.
During Hold condition, the Serial Data output (DQ1) is in high impedance, and Serial Data
input (DQ0) and Serial Clock (C) are Don't Care.
To start the Hold condition, the device must be selected, with Chip Select (S) driven Low.
For devices featuring Reset instead of Hold functionality, the Reset (Reset) input provides a
hardware reset for the memory.
When Reset (Reset) is driven High, the memory is in the normal operating mode. When
Reset (Reset) is driven Low, the memory will enter the Reset mode. In this mode, the output
is high impedance.
Driving Reset (Reset) Low while an internal operation is in progress will affect this operation
(write, program or erase cycle) and data may be lost.
In the Extended SPI protocol, during the QOFR, QIOFR, QIFP and the Quad Extended Fast
Program (QIEFP) instructions, the Hold (Reset) / DQ3 is used as an input/output (DQ3
functionality).
In QIO-SPI, the Hold (Reset) / DQ3 pin acts as an I/O (DQ3 functionality), and the HOLD
(Reset) functionality disabled when the device is selected. When the device is deselected (S
signal is high), in parts with Reset functionality, it is possible to reset the device unless this
functionality is not disabled by mean of dedicated registers bits.
The HOLD (Reset) functionality can be disabled using bit 3 of the NVCR or bit 4 of the VECR.
17/180
Related parts for N25Q128A13B1240E
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![N25Q128](/images/manufacturer_photos/0/4/484/numonyx_tmb.jpg)
Part Number:
Description:
128-mbit 3 V, Multiple I/o, 4-kbyte Subsector Erase On Boot Sectors, Xip Enabled, Serial Flash Memory With 108 Mhz Spi Bus Interface
Manufacturer:
Numonyx
Datasheet:
![rc28f320j3d75d](/images/manufacturer_photos/0/4/484/numonyx_tmb.jpg)
Part Number:
Description:
Numonyx™ Embedded Flash Memory J3 V. D
Manufacturer:
Numonyx
Datasheet:
![JS28F256M29EWH](/images/manufacturer_photos/0/4/484/numonyx_tmb.jpg)
Part Number:
Description:
Manufacturer:
NUMONYX
Datasheet:
![JS28F640P33T85](/images/manufacturer_photos/0/4/484/numonyx_tmb.jpg)
Part Number:
Description:
Manufacturer:
NUMONYX
Datasheet: