G6JU2FLYDC3 Omron, G6JU2FLYDC3 Datasheet

Page 1

... G6J-Y Ultra-compact and Slim DPDT Relay • Dimensions 5.7W x 10.6L mm provide a mounting area reduction of approx. 56% when compared with the OMRON G6S. • Dielectric strength of 1,500 VAC and an impulse withstand voltage of 2,500 V for μs (conforms to Telcordia specifications (formerly Bellcore)). • Conforms to FCC Part 68 requirments (1,500 V,10 x 160 μs). ...

Page 2

Specifications ■ Contact Data Rated load Contact material Max. carry current Max. operating voltage Max. operating current Max. switching capacity Min. permissible load (see note) Note: This value was measured at a switching frequency of 120 operations/min and the criterion ...

Page 3

... The insulation resistance was measured with a 500-VDC Megger Tester applied to the same parts as those for checking the dielectric strength. 4. The above values are initial values. Standard non-latching relays G6J-2P-Y, G6J-2FS-Y, G6J-2FL max. (approx. 0.9 ms min. (at 100% rated coil voltage) 2 (approx. 100G) 2 (approx. 75G) Surface-mounting Relay Single coil latching relays G6JU-2P-Y, G6JU-2FS-Y, G6JU-2FL-Y G6J-Y 59 ...

Page 4

... Unit: m Sample: G6J-2P-Y Z' Number of Relays Conditions: Shock is applied in ±X, ±Y, and ±Z directions three times each with and without energizing the Relays to check the number of contact malfunctions. Contact Reliability Test (See note.) 1,000 Sample: G6J-2P-Y NO contact Number of Relays: 10 Test conditions: 10 μA resistive load ...

Page 5

... Frequency (MHz) Surface-mounting Relay Average value + +20 +10 0 −10 −20 Sample: G6J-2P-Y Must Operate voltage Number of Relays: 5 Must Release voltage −30 −1,200 −800 −400 0 400 800 1,200 External magnetic field (A/m) Average value 0 3.5 3 2.5 2-pole return loss 2 1-pole return loss 1 ...

Page 6

... Must Operate bounce time Must Operate bounce time 35 Must Release bounce time 35 Must Release bounce time Sample: G6J-2P-Y Sample: G6J-2P-Y Number of Relays: 30 Number of Relays 0.5 1 1 0.5 1 1.5 2 2.5 3 Time (ms) Time (ms) G6J-Y Vibration Resistance 5.0 4.0 3.0 2.0 1.0 Must Operate voltage 0 ...

Page 7

Dimensions Note: All units are in millimeters unless otherwise stated. A tolerance of ±0.3 (±0.01) applies to every dimension in the following drawings unless otherwise stated. G6J-2P-Y G6JU-2P-Y 10.6 9 3.5 0.3 1.5 3.2 5.4 7.6 G6J-2FS-Y G6JU-2FS-Y 10.6 10.0 ...

Page 8

... Stick Packing and Tape Packing 1. Stick Packing Relays in stick packing are arranged so that the orientation mark of each Relay is on the left side. Always confirm that the Relays are in the correct orientation when mounting the Relays to the PCBs. Orientation of Relays Stopper (gray) Stick length: 555 mm (stopper not included) No ...

Page 9

... G6J-2P-Y, 2FS-Y, 2FL- VDC G6JU-2P-Y, 2FS-Y, 2FL- VDC • The thickness of cream solder to be applied should be between 150 and 200 μm on OMRON's recommended PCB pattern. • In order to perform correct soldering recommended that the correct soldering conditions be maintained as shown below on the left-hand side. ...

Page 10

... Mounting Latching Relays The Latching Relays are reset before shipping. If excessive vibration or shock is imposed, however, the Latching Relays may be set acci- dentally. Be sure to apply a reset signal before use. Make sure that the vibration or shock that is generated by other devices on the same panel does not exceed the rated value of the Latching Relays ...

Page 11

... Seller within 30 days of receipt of shipment. III. PRECAUTIONS 1. Suitability THE BUYER’S SOLE RESPOINSIBILITY TO ENSURE THAT ANY OMRON PRODUCT IS FIT AND SUFFICIENT FOR USE IN A MOTORIZED VEHICLE APPLICATION. BUYER SHALL BE SOLELY RESPONSIBLE FOR DETERMINING APPROPRIATENESS OF THE PARTICULAR PRODUCT WITH RESPECT TO THE BUYER’ ...

Page 12

... THE OMRON PRODUCT IS PROPERLY RATED AND INSTALLED FOR THE INTENDED USE WITHIN THE OVERALL EQUIPMENT OR SYSTEM. Complete “Terms and Conditions of Sale” for product purchase and use are on Omron’s website at http://www.components.omron.com – under the “About Us” tab, in the Legal Matters section. ...